Use of the target zone, Trouble shooting

Use of the target zone

When the target cadence zone is turned On, cadence is monitored against set zone range. When the cadence is out of the zone during measurement, the computer sounds an alarm and notifies a rider by flashing .

For training aiming at a cadence of 80 to 120 rpm, set the lower limit to 80 and upper limit to 120.

Then, the computer emits an alarm when the cadence falls below 79 rpm, or rises above 121 rpm.

Once the target zone is set to On, the relevant data are recorded to the file and the time in zone the time in the zone, time above the zone, and time below the zone and their percent- ages can be viewed in the file view (page 23).

Cadence zone

Cadence 60

100

120

140

160

180

200

rpm

CDC.ZONE

ZONE

Alarm

80 - 120 rpm

Default zone

Target training zone

*You can enter any upper/lower limit to the zone.

*For the target zone, you can change on/off and the upper/lower limit of the target zone from the menu screen “Setting the target cadence zone” (page 33).

*On/off of the alarm sound is selected from the menu screen “Setting sound” (page 32).

Trouble shooting

If a malfunction occurs, check the following before contacting CatEye or your retailer for repair or service.

Trouble on display

Trouble

Check Items

Remedy

Display motion be-

Is the surrounding temperature

Temperatures below freezing may re-

comes slower.

low (below zero degree Celsius

sult in slower screen response. Data

or 32 degrees Fahrenheit)?

is not affected.

Flashes on the

The remaining battery ca-

Replace it with a new battery

screen.

pacity for the computer is

(CR2032) immediately.

low.

After replacement, be sure to perform

the restarting operation (page 10).

No displays appear.

Is the battery for the com-

Replace it with a new battery

puter empty?

(CR2032).

After replacement, be sure to perform

the restarting operation (page 10).

Meaningless display

Perform the restarting operation

appears.

(page 10).

Cannot measure the

Have you checked the sensor ID?

Check the speed sensor ID (page 28)

trip speed (cadence)

Is the computer ID Synch'ed

for SP1 (speed sensor 1) or SP2

with somebody else's sensor?

(speed sensor 2).

Is the Speed and Cadence

If the Speed and Cadence sensor

sensor icon on

, ?

icon is off , , the computer can-

not receive data. Press the M1/+ or

M2/- button once to turn on the icon.

Check whether the distance

Adjust the position of the speed (ca-

between the speed (ca-

dence) sensor and that of the mag-

dence) sensor and the mag-

net correctly. (See “How to install the

net is too large.

unit on your bicycle” on page 6.)

Is the sensor zone of the

speed (cadence) sensor off

the center of the magnet?

Has the power-saving function

Press any button on the computer

been activated, showing only

to cancel the power-saving function.

date/clock on the screen?

Is the battery for the speed

Replace it with a new battery

sensor empty?

(CR2032).

After replacement, be sure to press

the RESET button on the speed

sensor.

Pressing the LT button

Check whether

lights

Replace it with a new battery

does not turn on a light.

up on the computer screen.

(CR2032).

The remaining battery ca-

After replacement, be sure to

pacity for the computer is

perform the restarting operation

low.

(page 10).

ENG

ENG-34

Continue ENG-35