18.
Insert bolt (31) through left side short elevator tube (29), then stretch spring or springs (34) onto bolt (31). Insert bolt (31) through right side short elevator tube (29) and secure with nut (35).
WARNING!
USE EYE PROTECTION
WHEN INSTALLING
SPRINGS.
29
31
35
29
34
19.
Secure pole end with tape (not included). Fill pole with concrete approximately 1” (2.54 cm) below bottom elevator hole as shown.
NOTE: Make sure that concrete does not bulge from the end of pole assembly. Allow concrete to completely cure.
IMPORTANT!:
Failure to fill your pole completely with concrete as described in these instructions will void all warranties written and implied.
C
O
N
C
RETE
1" (2.54 cm)
1
IMPORTANT!:
WAIT A MINIMUM OF 24 HOURS BEFORE GOING ON TO NEXT STEP22.
CONCRETE MUST CURE.
23 | 02/04 | P/N 21145507 |