Huffy Sports Basketball Systems manual U.S.1-800-558-5234 and Canada

Page 3

WARNING

FAILURE TO FOLLOW THESE WARNINGS MAY RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE.

Owner must ensure that all players know and follow

these rules for safe operation of the system.

DO NOT HANG on the rim or any part of the system including backboard, support braces or net.

During play, especially when performing dunk type activities, keep player's face away from the backboard, rim and net. Serious injury could occur if teeth/face come in contact with backboard, rim or net.

Do not slide, climb, shake or play on pole.

When adjusting height, keep hands and fingers away from moving parts.

Do not allow children to move or adjust system.

During play, do not wear jewelry (rings, watches, necklaces, etc.). Objects may entangle in net.

Keep organic material away from pole base. Grass, litter, etc. could cause corrosion and/or deterioration.

Check pole system for signs of corrosion (rust, pitting, chipping) and repaint with exterior enamel paint. If rust has penetrated through the steel anywhere, replace the pole immediately.

Check system before each use for proper ballast, loose hardware, excessive wear and signs of corrosion and repair before use.

Check system before each use for instability.

Never play on damaged equipment.

Keep pole top covered with cap at all times.

See instruction manual for proper installation.

In the U.S.:1-800-558-5234 and Canada: 1-800-284-8339

201240 2/99

3

02/04

P/N 21145507

Image 3
Contents Inground System Before YOU Start U.S.1-800-558-5234 and Canada Safety Instructions Warranty Card Parts List See Hardware Identifier Hardware Identifier Bolts & Screws Section a Assemble the Pole TOP Middle FIG. a Keep flange pushed down To concrete and leveled Taped reference marks 02/04 Side Access Section B Assemble the Backboard To Elevator Tubes 21145507 02/04 02/04 21145507 02/04 Surface of acrylic 21145507 02/04 Section C Attach the BACKBOARD/ELEVATOR To Pole System 21145507 02/04 USE EYE Protection When Installing Springs Install clips Insert net into bottom of clip as shown Use wedge to tap cap of ground sleeve until tight 24A 10 ft 05 m