Huffy Sports Basketball Systems manual Use wedge to tap cap of ground sleeve until tight

Page 26

IMPORTANT!:

WAIT A MINIMUM OF 24 HOURS BEFORE GOING ON TO NEXT STEPS. CONCRETE MUST CURE.

22.After concrete has cured, remove tape, install pole cap (40), fit pole assembly into sleeve (4).

IMPORTANT! Position pole assembly so the elevator assembly is perpendicular with playing surface.

IMPORTANT! The elevator holes MUST be parallel with playing surface.

WARNING

TWO PERSON MINIMUM REQUIRED

FOR THIS PROCEDURE. NOT

FOLLOWING RECOMMENDATION

MAY RESULT IN SERIOUS BODILY

INJURY AND/OR PROPERTY

DAMAGE.

40

4

PLAYING SURFACE

23.Use wedge to tap cap of ground sleeve until tight.

5

P/N 21145507 02/04

26

Image 26
Contents Inground System Before YOU Start U.S.1-800-558-5234 and Canada Safety Instructions Warranty Card Parts List See Hardware Identifier Hardware Identifier Bolts & Screws Section a Assemble the Pole TOP Middle FIG. a Keep flange pushed down To concrete and leveled Taped reference marks 02/04 Side Access Section B Assemble the Backboard To Elevator Tubes 21145507 02/04 02/04 21145507 02/04 Surface of acrylic 21145507 02/04 Section C Attach the BACKBOARD/ELEVATOR To Pole System 21145507 02/04 USE EYE Protection When Installing Springs Install clips Insert net into bottom of clip as shown Use wedge to tap cap of ground sleeve until tight 24A 10 ft 05 m