ASSEMBLY
Assembly requires two persons. | Place all parts of the exercise cycle in a cleared area and remove the pack- | |
ing materials. Do not dispose of the packing materials until assembly is completed. |
| |
In addition to the included allen wrenches, assembly requires a phillips screwdriver | , an | |
adjustable wrench | , and a rubber mallet | . |
As you assemble the exercise cycle, use the drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page
22. The second number refers to the quantity used in assembly.Note: Some small parts may have been pre-
assembled for shipping. If a part is not in the parts bag, check to see if it has been
M4 x 16mm | M5 x 16mm | M6 Washer | M8 Split | M8 Nylon Jamnut |
Screw | Screw | |||
|
| Washer |
1/4” x 19mm | 1/4” x 45mm |
| M8 x 36mm Button |
Screw | Screw |
| |
|
|
| Bolt |
|
|
|
|
|
|
|
|
M8 x 25mm Button | M8 x 40mm Carriage | M10 x 27mm |
Screw | Bolt | Patch Screw |
1.Identify the Front Stabilizer (9), which has Wheels (31) attached to it. While another person lifts the front of the Frame (1), attach the Front Stabilizer to the Frame
with two M8 x 25mm Button Screws (47) and two M8 Split Washers (52).
1 |
1 |
52 |
47 |
9 |
31 |
5