Horizon Fitness CSE 3.5 manual Remove PRE-ATTACHED Bolts & Washers from Console Mast

INTRODUCTION IMPORTANT

PRECAUTIONS

ASSEMBLY

BEFORE

YOU BEGIN

ELLIPTICAL CONDITIONING TROUBLESHOOTING LIMITED

OPERATION GUIDELINES & MAINTENANCE WARRANTY

10

A S S E M B LY STEP 3

��������������

����������

����������

����������������������

��������������������� ���������

A)Open HARDWARE BAG FOR STEP 3.

B)Attach the PERIMETER BARS using 4 BOLTS (E).

C)Attach REAR STABILIZER COVER using 2 SCREWS (F).

D)Attach FRONT STABILIZER COVERS using 2 SCREWS (F) for each side.

HARDWARE BAG FOR STEP 3 CONTENTS :

�������������	���������
	�����
������	������

A S S E M B LY STEP 4

���������������

	������������
������������	����������

������������

�������������

���������������

NOTE: There is NO hardware bag for this step. All hardware is pre-installed.

A)Remove PRE-ATTACHED BOLTS & WASHERS from CONSOLE MAST.

B)Slide LOWER HANDLEBARS onto CONSOLE MAST and attach by re-inserting PRE-ATTACHED BOLTS & WASHERS.

C)Attach UPPER HANDLEBARS to LOWER HANDLEBARS using PRE-ATTACHED SET SCREWS.

WARNING	After handlebars are assembled they will rotate freely – be cautious. Until the
	machine is fully assembled, do not grab the handlebars for support.

11

IMPORTANT PRECAUTIONS INTRODUCTION

ASSEMBLY

BEFORE YOU BEGIN

LIMITED TROUBLESHOOTING CONDITIONING ELLIPTICAL WARRANTY & MAINTENANCE GUIDELINES OPERATION

CSE3.5-4.5 Elliptical Rev 0.4.indd 10-11 6/3/05 5:42:08 PM