Precor 835 warranty Making Sure the Unit Is Stable, To level the unit

Page 24

22

Assembling and Maintaining the 835 Climber

8.Clean the foot steps, plastic covers and upright support with a soft cloth or wipe moistened with an appropriate cleaning solution. For more information about which cleaners to use, refer to Daily Cleaning.

9.Level the climber as described in the section Making Sure the Unit Is Stable.

Important: Do not allow anyone to use the climber until it has been leveled and made stable.

Making Sure the Unit Is Stable

Make sure the unit is level before allowing anyone to use it.

CAUTION: To eliminate movement, make sure the adjustable feet are in contact with the floor.

To level the unit:

1.Gently rock the unit. If there is any movement, ask your assistant to tip the unit to one side while you locate the adjustable feet.

2.Correct the height of each adjustable foot as follows.

If you want to …

Then turn the adjustable feet …

Raise the unit

Counterclockwise

Lower the unit

Clockwise

Important: Place the unit on a flat surface. Rotating the adjustable feet cannot compensate for extremely uneven surfaces.

When you are finished adjusting the unit, place the unit on the floor and recheck that it is level.

Image 24
Contents Assembling and Maintaining the 835 Climber Page Page Edition Information Trademark NoteIntellectual Property Notice Important Safety Instructions Safety PrecautionsAssembling and Maintaining the 835 Climber Educating Users Hazardous Materials and Proper Disposal Product Recycling and DisposalRegulatory Notices for the Rfid Module Radio Frequency Interference RFI Federal Communications Commission, PartIndustry Canada Safety Approvals for Cardiovascular Equipment Regulatory Notices for Cardiovascular Exercise EquipmentEuropean Applications Cardiovascular Type EquipmentUser’s authority to operate the equipment Obtaining Service Obtaining Updated Documentation IEC-320 C13 and C14 plugsTable of Contents Commercial Cardiovascular Equipment Limited Warranty Preparing for Installation Assembling the ClimberUnpacking the Equipment Hardware Kit not to scale FastenersAssembling the Climber Required ToolsTo assemble the main climber mechanism Important Do not tighten the two hex nuts at this time Slide the plastic top cover onto the upright support Securing the upright support to the climber base Sliding the grommet into place Attaching the Handrails To attach the handrailsAttaching the end caps Making Sure the Unit Is Stable To level the unitInstalling the Console Threading the Cable AssemblyTo thread the cable assembly Console positioning on base unit Connecting Cables P30 LocationCompleting the Console Installation To complete the installationVerifying That the Heart Rate Display Is Operational To verify that the heart rate display is operationalMaintenance Daily CleaningDaily Inspection Storing the Chest StrapMoving the Equipment Long-Term StorageTo move the climber Assembling and Maintaining the 835 Climber Self-Powered Features Rate of MotionSymptoms of a Low Battery Informational Displays Prior to ShutdownUsing the Optional Power Adapter Optional Power Adapter KitReplacing the Battery Commercial Cardiovascular Equipment Limited Warranty Limited WarrantyWarranty Periods and Coverage Conditions and Restrictions Exclusive Remedies Exclusion of Consequential and Incidental Damages Complete this portion and keep for your recordsCommercial Cardiovascular Equipment Limited Warranty Assembling and Maintaining the 835 Climber Page Precor Incorporated