Precor 835 warranty Maintenance, Daily Cleaning

Page 29

Chapter 3

Maintenance

To keep the equipment functioning properly, perform the minor maintenance tasks in this section at the intervals shown on the maintenance checklist. Failure to maintain the equipment as described in this section could void the Precor Limited Warranty.

DANGER To reduce the risk of electrical shock, always disconnect the equipment from its power source before cleaning it or performing any maintenance tasks. If the equipment is self-powered but also uses the optional power adapter, disconnect the adapter.

Daily Cleaning

Precor recommends that you clean the equipment before and after each exercise session. To remove dust and dirt from the equipment, wipe all exposed surfaces with a soft cloth that you have moistened with one of the following cleaners:

A solution of 30 parts of water to 1 part of Simple Green® (for more information, visit www.simplegreen.com)

ENVIR-O-SAFE oxygen enhanced cleaner or multi-task cleaner concentrate, diluted according to the manufacturer’s instructions (for more information, visit www.daleyinternational.com)

Image 29

Contents Assembling and Maintaining the 835 Climber Page Page Intellectual Property Notice Edition InformationTrademark Note Safety Precautions Important Safety InstructionsAssembling and Maintaining the 835 Climber Educating Users Regulatory Notices for the Rfid Module Hazardous Materials and Proper DisposalProduct Recycling and Disposal Industry Canada Radio Frequency Interference RFIFederal Communications Commission, Part Regulatory Notices for Cardiovascular Exercise Equipment Safety Approvals for Cardiovascular EquipmentEuropean Applications Cardiovascular Type EquipmentUser’s authority to operate the equipment IEC-320 C13 and C14 plugs Obtaining Service Obtaining Updated DocumentationTable of Contents Commercial Cardiovascular Equipment Limited Warranty Unpacking the Equipment Preparing for InstallationAssembling the Climber Fasteners Hardware Kit not to scaleTo assemble the main climber mechanism Assembling the ClimberRequired Tools Important Do not tighten the two hex nuts at this time Slide the plastic top cover onto the upright support Securing the upright support to the climber base Sliding the grommet into place To attach the handrails Attaching the HandrailsAttaching the end caps To level the unit Making Sure the Unit Is StableTo thread the cable assembly Installing the ConsoleThreading the Cable Assembly Console positioning on base unit Location Connecting Cables P30To complete the installation Completing the Console InstallationVerifying That the Heart Rate Display Is Operational To verify that the heart rate display is operationalDaily Cleaning MaintenanceStoring the Chest Strap Daily InspectionTo move the climber Moving the EquipmentLong-Term Storage Assembling and Maintaining the 835 Climber Rate of Motion Self-Powered FeaturesInformational Displays Prior to Shutdown Symptoms of a Low BatteryOptional Power Adapter Kit Using the Optional Power AdapterReplacing the Battery Warranty Periods and Coverage Commercial Cardiovascular Equipment Limited WarrantyLimited Warranty Conditions and Restrictions Exclusive Remedies Complete this portion and keep for your records Exclusion of Consequential and Incidental DamagesCommercial Cardiovascular Equipment Limited Warranty Assembling and Maintaining the 835 Climber Page Precor Incorporated