Chapter 2
Installing the Console
To make installation easier, all Precor Experience Series consoles use the same mounting hardware and connector locations whenever possible. The installation sequence for any of them is as follows:
Threading the cable assembly
Connecting cables
Completing the installation (tightening the mounting screws and attaching the back cover)
The following sections describe how to perform these tasks.
Threading the Cable Assembly
Earlier in the installation, you threaded the necessary cables through the frame of the base unit and out the passthrough opening in the console mount. As you line up the back plate on the console with the console mount, you must make sure that the cable assembly passes correctly through the openings in both components.
Important: Before you begin the following procedure, remove the rear cover from the control console. Set the cover and its mounting hardware aside for later use.
To thread the cable assembly:
1.Make sure that as much of each cable as possible passes through the opening in the middle of the console mount on the base unit.
2.Position the console over the console mount.