Precor EFX 883, EFX 833 To attach the handlebars, Clamp screw location, EFX handlebar bracket

Assembling the EFX 23

To attach the handlebars:

Important: Attach one handlebar at a time.

1.Use a ³₁₆-inch hex wrench to loosen the two screws in the handlebar clamp. Refer to the following illustration for the location of these fasteners.

Figure 14: Clamp screw location, EFX handlebar bracket

2.Connect the heart rate cable from the console to the heart rate cable from the handlebars and place excess cable inside the handlebar.

Figure 15: Threading of the heart rate cable

Important: Do not stretch, crimp, or damage the cable. Cables damaged by improper installation will not be covered by the Precor Limited Warranty.

3.Insert the right handlebar into the handlebar clamp until the foam grip touches the side of the handlebar clamp.