Precor 5.25 manual Viewing the Error Log, ‐Error 40 AT 1234567 Strides 1714 Hours

1.At the Precor banner, press and hold ENTER while pressing the following keys in sequence without pause:

RESET, CROSSRAMP ▲, RESISTANCE ▼

The software part numbers scroll across the center display while the odometer and hour meter scroll across the lower display.

Note: If there are no errors in the log, NO ERRORS appears on the display.

Most recent	The hour meter at the
	time the error was

1‐Error 40 AT 1234567 STRIDES 1714 HOURS

2.Write the software part numbers below. You will need these numbers if you call Customer Support with questions. This information will help rule out any software-related problems:

Error code

Odometer reading at the time the error

UPPER: ___________________

LOWER: ___________________

3.When you are ready, press RESET to return to the Precor banner.

Viewing the Error Log

The error log displays information about errors that may have occurred while using the EFX. Up to ten errors are recorded along with the odometer and hour meter values at the time the error occurred.

1.At the Precor banner, press and hold the RESET key for at least four seconds to view the error log. The most recent error recorded appears on the lower display. Refer to Figure 8.

Figure 8: Error log

Owner’s Manual: Advanced Programming and Troubleshooting 37