Precor EC 850 owner manual Getting Service

Page 24

7.Test the Hall 1 speed sensor by SLOWLY moving the pedals. Continue pedaling for about 1 minute. The asterisk to the right of “Hall 1” will blink on and off if the sensor is working correctly. If the asterisk stays solid, the cycle needs servicing. Please note that only Hall 1 is used; ignore Hall 2.

8.To exit the Diagnostic program, either turn the cycle OFF then ON, or press ENTER/RESET three times. In either case, the initial start-up prompt, “Choose Workout Program,” appears.

Getting Service

Do not attempt to service an EC850 cycle yourself except for the maintenance and diagnostic tasks described in this manual. The EC850 cycle does not contain any user-serviceable parts.

To contact a Precor Commercial Products Customer Service Representative, call 1-800-347-4404.

page 24

Image 24

Contents EC850 Safety Information Table of Contents Before You Begin About this ManualSetting Up the EC850 Professional Cycle Installation RequirementsInterconnecting Cycles Using the Club Setting Program EC850 Using the EC850 Professional Cycle Understanding the Electronic ConsoleKeypad Right Display Adjusting the Seat WindowAdjusting the Handlebars Photo 2 Adjusting the seatUsing Manual Mode Workout Program Turning the Cycle on and OFFExercising on the EC850 Cycle Profiles Page EC850 Designing a Customized CoursePage Getting the Most Out of Your Workout Muscles exercised during an EC850 workoutHeart Rate Training Zones How Hard Should I Exercise?How Long Should I Exercise? How Often Should I Exercise?Cleaning the Cycle Using the Diagnostic ProgramMaintaining the EC850 Professional Cycle Diagnostic Getting Service Appendix A. Specifications SpecificationsChassis ReadoutsUSA