Using the Club Setting Program

The Club Setting Program lets you customize your cycle with the following features:

•Language—The words displayed on the electronic console can appear in one of the three languages (French, German, or English). Typically, on the cycle you buy, the language is preset to English.

•Workout time—You can set a workout time limit between 2 and 60 minutes. For example, if a club owner sets the maximum workout time to 20 minutes, the cycle would allow users to specify a workout time from 2 to 20 minutes. Users could not specify a workout time longer than 20 minutes. When you buy the cycle, it is set to a maximum workout time of 60 minutes.

•Measurement system—You can choose between U.S. Standard or Metric. Typically, the cycle you buy is set to U.S. Standard.

Accessing the Club Setting program requires combining specific keys on the electronic console. This design helps secure the cycle from unauthorized access and changes.

To use the Club Setting program, take the following steps:

1.Make sure that the cycle is located in an appropriate place and plugged in.

2.If the cycle is turned OFF, turn it ON using the ON/OFF power switch. This switch is located on the front of the cycle, near the power cord.

3.To display the initial start-up prompt, press the ON key.

Note: If the cycle is already ON and EC850 is scrolling across the bottom of the display. You can press any key and the initial start-up prompt, “Choose Workout Program ” will appear.

4.When the start-up prompt “Choose Workout Program” appears, access the Club Settings program by simultaneously pressing and holding the ON and keys for a minimum of 5 seconds.

5.Release both keys when the Club Settings screen appears on the console.

6.At the “Enter Language Selection” prompt, specify the language you want

by using the and keys. Press ENTER/RESET when the desired language is displayed. The Club Setting screen appears as shown in Diagram 1.

page 6