Turning Analog Direct On and Off

You can enjoy the sound closer to the original source by overriding the sound adjustments such as Midnight Mode (see page 16), Bass Boost (see page 18), Equalization pattern (see page 28), speaker output level adjustments (see page 28), and Surround and DSP modes (see pages 30 to 35). You can only adjust the volume level and the subwoofer output level while Analog Direct is in use.

•Once you have made an adjustment, it is memorized for each analog source.

Changing the Source Name	Remote
	NOT

When you have connected a CD recorder to the TAPE/CDR IN jacks or a DBS tuner to the TV SOUND/DBS IN jacks on the rear panel, change the source name which will be shown on the display.

Press ANALOG DIRECT so that “A DIRECT” appears on the display.

The lamp on the button also lights up.

•Each time you press the button, Analog Direct turns on and off (the lamp goes off) alternately.

Notes:

•When digital input mode is in use, Analog Direct is not available.

•Turning on Surround or DSP mode cancels Analog Direct and previously selected sound adjustments are recalled.

•If Analog Direct is in use, Midnight Mode (see page 16) is temporarily canceled.

•Turning on Analog Direct cancels Input Attenuator (see page 16) and CC Converter (see below).

Making Sounds Natural

JVC’s CC (Compensative Compression) Converter eliminates jitter and ripples, achieving a drastic reduction in digital distortion by processing the digital music data in 24 bit-quantization and by expanding the sampling frequency to 128 kHz (for fs 32 kHz signals)/176.4 kHz (for fs 44.1 kHz signals)/192 kHz (for fs 48 kHz signals) on the front speakers.

By using CC Converter, you can obtain a natural sound field from both digital and analog sources.

Press CC CONVERTER so that the lamp on the button lights up.

•Each time you press the button, CC Converter turns on and off (the lamp goes off) alternately.

Note:

You cannot use this function while Analog Direct is in use. If you turn on Analog Direct while this function is in use, this function will be canceled.

When changing the source name from TV to DBS:

1.Press TV SOUND/DBS.

• Make sure “TV” appears on the display.

2.Press and hold TV SOUND/DBS until “ASSGN DBS” appears on the display.

ANALOG

L	R LINEAR PCM

SPEAKERS 1

VOLUME

Note:

When connecting a DBS tuner to the TV SOUND/DBS IN jacks, change the source name to DBS, which will be shown on the display when selected as the source. Otherwise, you cannot view any picture from DBS tuner.

When changing the source name from TAPE to CDR:

1.Press TAPE/CDR.

• Make sure “TAPE” appears on the display.

2.Press and hold TAPE/CDR until “ASSGN CDR” appears on the display.

To change the source name to TV and TAPE, repeat the same

procedure above.

Note:

Without changing the source name, you can still use the connected components. However, there may be some inconvenience.

–“TAPE” or “TV” will appear on the display when you select the CD recorder or DBS tuner.

–You cannot use the digital input (see pages 15 and 16) for the CD recorder.