JVC RX-888VBK Adjusting the Volume, Selecting the Front Speakers, Etc, Turn Source Selector to

When playing a digital source through a digital terminal

Adjusting the Volume

•The DIGITAL SOURCE FORMAT lamps on the front panel indicate what type of the digital signal comes into the receiver.

On the front panel:

To increase the volume, turn MASTER

MASTER VOLUME

–

DIGITAL SOURCE FORMAT

DOLBY LINEAR

DTS DIGITAL PCM

DTS:

Lights up when DTS Digital Surround signals (see page 21) come in.

DOLBY DIGITAL:

Lights up when Dolby Digital signals (see page 21) come in.

LINEAR PCM:

Lights up when Linear PCM signals come in.

VOLUME clockwise.

To decrease the volume, turn it counterclockwise.

•When you turn MASTER VOLUME rapidly, the volume level also changes rapidly.

•When you turn MASTER VOLUME slowly, the volume level also changes slowly.

From the remote control:

+

•The signal indicators also light up on the display to indicate the incoming channel signals. (Only the indicators for the incoming signals light up.)

To increase the volume, press VOLUME +. To decrease the volume, press VOLUME –.

CAUTION:

VOLUME

L C R

LFE

LS S RS

L: Left front channel

R: Right front channel

C: Center channel

LS: Left rear channel

RS: Right rear channel

S: Rear channel (monaural)

LFE: Subwoofer channel

Always set the volume to the minimum before starting any source. If the volume is set at its high level, the sudden blast of sound energy can permanently damage your hearing and/or ruin your speakers.

Note:

The volume level can be adjusted within the range of “0” (minimum) to “90” (maximum).

Selecting different sources for picture and sound

You can watch picture from a video component while listening to

Selecting the Front Speakers

On the front panel ONLY:

sound from another component.

On the front panel:

1.Press SOUND SELECT (INPUT ATT) briefly while viewing the picture from a video component such as the VCR or DVD player,

etc.

“SOUND SELECT” appears on the display.

SOUND SELECT

INPUT ATT.

When you have connected two pairs of the front speakers, you can select which to use.

Press SPEAKERS 1 or SPEAKERS 2 to select		SPEAKERS
the speaker to use.
	1	2

• Each time you press the button, the lamp on the respective button turns on and off. When the lamp on either button lights up, the respective speakers are activated.

IMPORTANT:

2. Turn SOURCE SELECTOR to	SOURCE SELECTOR
select the sound (except the TV
sound), while the indication of the
above step is still on the display.

From the remote control:

Press one of the audio source selecting buttons (CD, TAPE/MD, PHONO, FM/AM), while viewing the picture from a video component such as the VCR or DVD player, etc.

Notes:

•Once you have selected a video source, pictures of the selected source are sent to the TV until you select another video source.

•When you select “TV SOUND” as the source, this function does not work.

You can activate two pairs of the front speakers at the same time only when the SPEAKER LOAD SELECTOR on the rear panel is set to “HIGH” and when no signals are sent to the center and rear speakers. Otherwise, activating one pair of the speakers deactivates the other.

Note:

If you use any of the DSP modes other than the 3D-PHONIC modes with both front speakers activated, the speakers connected to the FRONT SPEAKERS 2 terminals are deactivated.