Trek 6i, 8i owner manual Using the buttons, Set

Page 14

Using the buttons

		When setting the computer, there
		are three ways to use the buttons. To
		help you remember, notice the way
	MH	each term is underlined. To help you
	MH	remember, these terms will look the
	Set	remember, these terms will look the
ODO	Set	same throughout the manual.
		Push- touch once
		Cycle - push repeatedly as needed
		Hold- push and hold in for two or
Mode		three seconds
Figure 11- Buttons on the Incite		The buttons on the computer are
6i computer		(Figure 11):

Set• button on the right side

Mode button on the bottom

To set the computer, you must Push, Cycle, or Hold the two buttons in a specific sequence.

12 Easy setup (ReSet)

Image 14

Contents Trek Incite 6i 920Contents Safety and general guidelines Watch the road when ridingFunctions Function ExplanationWheel Installation MountTo install the computer on handlebar Placing the computer on the handlebarTo install the computer on the stem Make sure the com- puter cannot be bounced offTo install the wheel magnet Placing the magnetAttaching the computer wire To attach the computer wireTo install the sensor Attaching the sensorTighten the nylon ties and trim the excess length Figure Easy setup ReSet Using the buttons SetTo set the computer To set 6i wheel sizeTo set 8i wheel size Select wheel screenCycle Mode to TRP To select the wheel for useTo set Clock Clock screenReStart- Getting ready to ride To ReStart set the Trip data to zeroAdditional information Changing modeUsing the computer in wet weather Removing the computer from the computer baseTroubleshooting Replacing the battery To replace the batteryBe careful to avoid losing the rubber O-ring seal Setting custom wheel size Selecting the custom value 4-digit numberPush Set To measure rollout for wheel size Measuring rollout for wheel sizeThis warranty does not cover Limited WarrantyThis warranty covers