Trek 6i, 8i owner manual Installation, Mount

Page 6

Installation

Stem mount

	Handlebar	Speed sensor
	mount	Speed sensor
	mount

Figure 3- Location on bicycle of sensors and computer

Tools needed:

•Electrical tape

•Slot-type screwdriver

•Phillips-type screwdriver

•Scissors

Installation

Image 6

Contents Trek Incite 6i 920Contents Safety and general guidelines Watch the road when ridingFunctions Function ExplanationWheel Installation MountTo install the computer on handlebar Placing the computer on the handlebarTo install the computer on the stem Make sure the com- puter cannot be bounced offTo install the wheel magnet Placing the magnetAttaching the computer wire To attach the computer wireTo install the sensor Attaching the sensorTighten the nylon ties and trim the excess length Figure Easy setup ReSet Using the buttons SetTo set the computer To set 6i wheel sizeTo set 8i wheel size Select wheel screenCycle Mode to TRP To select the wheel for useTo set Clock Clock screenReStart- Getting ready to ride To ReStart set the Trip data to zeroAdditional information Changing modeUsing the computer in wet weather Removing the computer from the computer baseTroubleshooting Replacing the battery To replace the batteryBe careful to avoid losing the rubber O-ring seal Setting custom wheel size Selecting the custom value 4-digit numberPush Set To measure rollout for wheel size Measuring rollout for wheel sizeLimited Warranty This warranty coversThis warranty does not cover