Trek 8i, 6i owner manual Troubleshooting

Page 21

Troubleshooting

The Incite 6i computer is designed to be easy to install and maintain. However, computers occasionally have problems. Table 3 shows some possible problems, causes, and solutions:

Table 3- Common problems and solutions

Blank screen	Computer is in shipping mode. Push a button.

	Battery is dead, or installed incorrectly. Reinstall good battery.

Erratic data	Magnet misaligned or too far away. Re-adjust magnet and sensor placement.

	Battery power is low. Replace battery.

No current speed	Magnet misaligned or too far away. Re-adjust magnet and sensor placement.

Speed is incorrect.	Wheel size is incorrect. Reset computer.

	Sensor is not reading magnet properly. Readjust magnet and sensor alignment.

Troubleshooting 19

Image 21

Contents 920 Trek Incite 6iContents Watch the road when riding Safety and general guidelinesFunction Explanation FunctionsWheel Mount InstallationPlacing the computer on the handlebar To install the computer on handlebarMake sure the com- puter cannot be bounced off To install the computer on the stemPlacing the magnet To install the wheel magnetTo attach the computer wire Attaching the computer wireAttaching the sensor To install the sensorTighten the nylon ties and trim the excess length Figure Easy setup ReSet Set Using the buttonsTo set 6i wheel size To set the computerSelect wheel screen To set 8i wheel sizeTo select the wheel for use Cycle Mode to TRPClock screen To set ClockTo ReStart set the Trip data to zero ReStart- Getting ready to rideUsing the computer in wet weather Changing modeAdditional information Removing the computer from the computer baseTroubleshooting To replace the battery Replacing the batteryBe careful to avoid losing the rubber O-ring seal Selecting the custom value 4-digit number Setting custom wheel sizePush Set Measuring rollout for wheel size To measure rollout for wheel sizeLimited Warranty This warranty coversThis warranty does not cover