Trek 8i, 6i owner manual Push Set

Page 25

ODO	Set
TME
AVG
MAX
TRP

Mode

3.Cycle Mode through the wheel sizes to the 4-digit number

4.Push Set•

The left-hand digit flashes.

5.Cycle Mode

The right-had digit changes.

6. Push Set• to select.

The second digit flashes.

7.Repeat steps 5 and 6 to select all four wheel-size digits.

8.Hold Set•

The computer returns to current speed.

Setting Custom Wheel Size

23

Image 25

Contents 920 Trek Incite 6iContents Watch the road when riding Safety and general guidelinesFunction Explanation FunctionsWheel Mount InstallationPlacing the computer on the handlebar To install the computer on handlebarMake sure the com- puter cannot be bounced off To install the computer on the stemPlacing the magnet To install the wheel magnetTo attach the computer wire Attaching the computer wireAttaching the sensor To install the sensorTighten the nylon ties and trim the excess length Figure Easy setup ReSet Set Using the buttonsTo set 6i wheel size To set the computerSelect wheel screen To set 8i wheel sizeTo select the wheel for use Cycle Mode to TRPClock screen To set ClockTo ReStart set the Trip data to zero ReStart- Getting ready to rideUsing the computer in wet weather Changing modeAdditional information Removing the computer from the computer baseTroubleshooting To replace the battery Replacing the batteryBe careful to avoid losing the rubber O-ring seal Selecting the custom value 4-digit number Setting custom wheel sizePush Set Measuring rollout for wheel size To measure rollout for wheel sizeThis warranty covers Limited WarrantyThis warranty does not cover