Trek 8i, 6i owner manual Be careful to avoid losing the rubber O-ring seal

Page 23

4.Lift the battery cover, exposing the battery.

Be careful to avoid losing the rubber O-ring seal.

5. Remove the old battery.

It may be possible to shake the battery out. Otherwise, carefully pry the battery up with a thin tool or knife blade.

6.Insert the new battery with the ‘cross’ and identifying label pointing up (Figure 17).

7.Replace the battery cover (and O-ring seal) and turn one-quarter turn clockwise.

Figure 17- The ‘cross’ on the bat- tery points up

Replacing the Battery

21

Image 23
Contents 920 Trek Incite 6iContents Watch the road when riding Safety and general guidelinesFunction Explanation FunctionsWheel Mount InstallationPlacing the computer on the handlebar To install the computer on handlebarMake sure the com- puter cannot be bounced off To install the computer on the stemPlacing the magnet To install the wheel magnetTo attach the computer wire Attaching the computer wireAttaching the sensor To install the sensorTighten the nylon ties and trim the excess length Figure Easy setup ReSet Set Using the buttonsTo set 6i wheel size To set the computerSelect wheel screen To set 8i wheel sizeTo select the wheel for use Cycle Mode to TRPClock screen To set ClockTo ReStart set the Trip data to zero ReStart- Getting ready to rideRemoving the computer from the computer base Changing modeUsing the computer in wet weather Additional informationTroubleshooting To replace the battery Replacing the batteryBe careful to avoid losing the rubber O-ring seal Selecting the custom value 4-digit number Setting custom wheel sizePush Set Measuring rollout for wheel size To measure rollout for wheel sizeThis warranty does not cover Limited WarrantyThis warranty covers