Trek 8i, 6i owner manual ReStart- Getting ready to ride, To ReStart set the Trip data to zero

Page 19

ODO

Set

TME

 

AVG

 

MAX

 

TRP

 

Mode

ReStart- Getting ready to ride

Your computer stores data for two intervals- since last ReSet and since last ReStart. ReSet sets ALL data to zero. ReStart sets only the Trip data to zero.

The trip modes include

TRP

TME

MAX

This operation sets all four values to zero, allowing the computer to display information for a single ride.

MH

MAX

Figure 15- MAX screen

To ReStart (set the Trip data to zero)

1.Cycle Mode to TRP (Figure 15).

2.Hold Set•, and do not let up until after completing step 3.

3.Hold Mode.

The Max setting ReStarts at ‘0’.

ReStart 17

Image 19
Contents 920 Trek Incite 6iContents Watch the road when riding Safety and general guidelinesFunction Explanation FunctionsWheel Mount InstallationPlacing the computer on the handlebar To install the computer on handlebarMake sure the com- puter cannot be bounced off To install the computer on the stemPlacing the magnet To install the wheel magnetTo attach the computer wire Attaching the computer wireAttaching the sensor To install the sensorTighten the nylon ties and trim the excess length Figure Easy setup ReSet Set Using the buttonsTo set 6i wheel size To set the computerSelect wheel screen To set 8i wheel sizeTo select the wheel for use Cycle Mode to TRPClock screen To set ClockTo ReStart set the Trip data to zero ReStart- Getting ready to rideRemoving the computer from the computer base Changing modeUsing the computer in wet weather Additional informationTroubleshooting To replace the battery Replacing the batteryBe careful to avoid losing the rubber O-ring seal Selecting the custom value 4-digit number Setting custom wheel sizePush Set Measuring rollout for wheel size To measure rollout for wheel sizeThis warranty covers Limited WarrantyThis warranty does not cover