ProForm 30464.0 user manual Assembly, Make sure that the power cord is unplugged

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe it off with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included hex keys and your own Phillips screwdriver , adjustable

wrench , scissors , rubber mallet , and needlenose pliers .

Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number after the parentheses is the quantity needed for assembly. Note: If a part is not in the parts bag, check to see if it is preattached to one of the parts to be assembled. To avoid damaging plastic parts, do not use power tools for assembly. Extra hardware may be included.

M4.2 x 19mm Tek	M5 x 16mm	M4.2 x 19mm	M4 x 10mm	M8 x 15mm
Screw (26)–6	Screw (85)–2	Screw (10)–6	Screw (84)–1
				Bolt (8)–6
M5 Star			M8 x 58mm Bolt (13)–4
Washer (7)–2		Extension Leg Nut
	M10 Flat Washer	(43)–4
	(14)–2
M8 Star
Washer (5)–6			M10 x 60mm Bolt (1)–2
	M8.5 Washer
	(32)–4
M10 Star
Washer (9)–6			M10 x 75mm Bolt (2)–4

1.Make sure that the power cord is unplugged.

Position the Base (52) and Extension Legs (45) upside-down as shown.

Attach six Base Pads (63) to the Base (52) and the Extension Legs (45) with six M4.2 x 19mm Tek Screws (26).

1	52	26
26		63
63			26
45		45	63
26			26
63		63
26		63

6