2. Have a second person hold the Base (52) in the | 2 |
|
|
position shown. |
|
| |
|
|
| |
Identify the Left Upright (53) (the Right Upright |
|
|
|
[54] has a large hole near the lower end). |
|
|
|
Hold the Left Upright (53) so the two small | Small Holes | 54 |
|
|
|
| |
holes for the latch assembly are on top as |
|
|
|
shown. Attach the Left Upright to the Base (52) |
|
|
|
with two M10 x 75mm Bolts (2) and two M10 Star |
| Large | 2 |
Washers (9). Do not tighten the Bolts yet. |
|
| |
| Hole |
| |
|
|
| |
Attach the Right Upright (54) in the same way. |
| 52 | 9 |
| 53 | ||
| 9 |
| |
|
| 2 |
|
3. Attach each Extension Leg (45) to the Base (52) | 3 |
|
|
with two M8 x 58mm Bolts (13), two M8.5 |
|
| |
|
| 45 | |
Washers (32), and two Extension Leg Nuts (43). |
|
| |
Note: The heads of the wheel bolts should be |
|
|
|
on the outside of the Extension Legs. |
|
|
|
Lower the Base (52) so that it is flat on the floor. | Bolt Head |
|
|
45 | 13 |
| |
| 43 | ||
|
| ||
|
|
| |
|
| 32 |
|
| 13 | 52 |
|
| 43 |
| |
|
|
| |
| 32 |
|
|
4. Position the Base (52) as close to the front of the | 4 |
|
|
treadmill as possible, as shown. |
|
| |
|
|
| |
See the upper inset drawing. Locate the wire | 39 | 39 | 54 |
|
|
| |
tie in the lower end of the Right Upright (54). Tie |
|
| Wire Tie |
the wire tie securely around the end of the Wire |
|
| |
Harness (39). Then, locate the other end of the |
|
|
|
wire tie in the upper end of the Right Upright. | 54 |
|
|
Pull the upper end of the wire tie until the Wire |
|
| |
52 |
|
| |
Harness is extending from the upper end of the |
|
| |
|
|
| |
Right Upright. Secure the Wire Harness to the |
|
|
|
Right Upright so that it will not fall inside. |
| 52 |
|
|
|
| |
See the lower inset drawing. Press the indi- |
|
| 54 |
cated Grommet (49) into the Right Upright (54). |
|
| 49 |
|
|
| |
|
| 39 |
|
| 7 |
|
|