13.Slide the Right Upright Cover (110) up against the Right Handrail (101). Attach the Right Upright Cover with two M4.2 x 16mm Screws (82). Be careful not to overtighten the
Screws.
Attach the Left Upright Cover (not shown) as de- scribed above.
See steps 5 and 7. Tighten the two M10 x 95mm Screws (8) and the two M10 x 68mm Screws (114).
14.Raise the Frame (56) to the position shown.
Have a second person hold the Frame until this step is completed.
Orient the Storage Latch (60) so that the large barrel and the latch knob are in the positions shown.
Attach the upper end of the Storage Latch (60) to the Frame (56) with a 3/8" x 1 3/4" Bolt (7) and a 3/8" Locknut (6).
Attach the lower end of the Storage Latch (60) to the Base (95) with two 3/8" x 2" Bolts (37) and two 3/8" Locknuts (6). Note: It may be neces- sary to move the Frame (56) back and forth to align the Storage Latch with the Base.
Lower the Frame (56) (see HOW TO LOWER THE TREADMILL FOR USE on page 24).
13 |
|
|
101 |
|
|
110 |
| 82 |
|
| |
14 |
|
|
56 |
|
|
6 |
| 7 |
Latch |
|
|
Knob |
|
|
Large |
| 60 |
Barrel |
| |
95 | 6 |
|
| 37 | |
|
|
15.Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. Keep the included hex keys in a secure place; one of the hex keys is used to adjust the walking belt (see pages 26 and 27).
13