11.Have a second person hold the console assem- bly near the Right Upright (89).
Connect the Upright Wire (88) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY BECOME DAMAGED WHEN YOU TURN ON THE POWER. Remove the wire tie from the Upright Wire. Then, insert the connectors into the Right Upright (89).
Set the console assembly on the Right Upright
(89)and the Left Upright (not shown). Make sure that no wires are pinched.
12.Start an M8 x 25mm Bolt (5) with an M8 Star Washer (10) and two 5/16" x 5/8" Screws (113) with two M8 Star Washers (10) into the Right Upright (89) and Right Handrail (101) as shown.
Do not tighten the Bolt and Screws yet. Attach the Left Handrail (not shown) as de- scribed above. Then, tighten both Bolts and all four Screws.
11 | Console |
|
| Assembly |
|
88 | Console Wire | Console |
Wire | ||
| Wire |
|
89 | Tie | 88 |
|
12 |
|
|
|
|
101 |
|
|
|
|
5 | 10 |
| 10 | 113 |
|
| 89 |
| |
|
|
|
|
12