ProForm PFTL99908.0 Make sure that the power cord is unplugged, Do not fully fold the Frame yet

1. Make sure that the power cord is unplugged.	1			38		83
With the help of a second person, carefully tip							Hole
the treadmill onto its left side. Partially fold the
Frame (56) so that the treadmill is more stable;							81
do not fully fold the Frame yet.								2
Cut the ties securing the Upright Wire (38) to the
Base (83). Locate the tie in the indicated hole in
the Base, and use the tie to pull the Upright Wire
out of the hole.
Attach a Base Foot (81) to the Base (83) in the		13	81
location shown with a Base Foot Spacer (13)	56			2
and a #8 x 1" Tek Screw (2). Then, attach an-
other Base Foot (81) with only a #8 x 1" Tek
Screw (2).
2. Attach a Wheel (84) to the Base (83) with a 3/8"	2
x 2" Bolt (4) and a 3/8" Nut (8). Do not over-
tighten the Nut; the Wheel must turn freely.			83
		4
		848
3. Identify the Right Upright (78) and the Right	3
Upright Spacer (79), which are marked with				78
stickers.
Insert the Upright Wire (38) through the Right		38
Upright Spacer (79) as shown. Then, set the							38
Right Upright Spacer (79) on the Base (83). Be
careful not to pinch the Upright Wire.		Long Tie			79
Have a second person hold the Right Upright
(78) near the Base (83). See the inset drawing.
Tie the long tie in the Right Upright securely
around the end of the Upright Wire (38). Then,							83
pull the other end of the long tie until the Upright
Wire is routed completely through the Right		78
Upright.	38
		Long
		Tie
	7