JVC RX-778VBK manual Mises en garde, précautions et indications diverses

Page 2

Warnings, Cautions and Others/

Mises en garde, précautions et indications diverses

CAUTION

To reduce the risk of electrical shocks, fire, etc.:

1.Do not remove screws, covers or cabinet.

2.Do not expose this appliance to rain or moisture.

ATTENTION

Afin d’éviter tout risque d’électrocution, d’incendie, etc.:

1.Ne pas enlever les vis ni les panneaux et ne pas ouvrir le coffret de l’appareil.

2.Ne pas exposer l’appareil à la pluie ni à l’humidité.

For Canada/pour le Canada

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE

BLADE OF PLUG TO WIDE SLOT, FULLY INSERT

ATTENTION: POUR EVITER LES CHOCS ELECTRIQUES,

INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA

BORNE CORRESPONDANTE DE LA PRISE ET POUSSER

JUSQUAU FOND

Caution –– POWER switch!

Disconnect the mains plug to shut the power off completely. The

POWER switch in any position does not disconnect the mains line.

The power can be remote controlled.

Attention –– Commutateur POWER!

Déconnecter la fiche de secteur pour couper complètement le courant. Le commutateur POWER ne coupe jamais complètement la ligne de secteur, quelle que soit sa position. Le courant peut être télécommandé.

Caution: Proper Ventilation

To avoide risk of electric shock and fire and to protect from dam- age.

Locate the apparatus as follows:

Front:	No obstructions open spacing.
Sides:	No obstructions in 10 cm from the sides.
Top:	No obstructions in 10 cm from the top.
Back:	No obstructions in 15 cm from the back
Bottom:	No obstructions, place on the level surface.

In addition, maintain the best possible air circulation as illustrated.

Attention: Ventilation Correcte

Pour éviter les chocs électriques, l’incendie et tout autre dégât. Disposer l’appareil en tenant compte des impératifs suivants

Avant:	Rien ne doit gêner le dégagement
Flancs:	Laisser 10 cm de dégagement latéral
Dessus:	Laisser 10 cm de dégagement supérieur
Arrière:	Laisser 15 cm de dégagement arrière
Dessous:	Rien ne doit obstruer par dessous; poser l’appareil
	sur une surface plate.

Veiller également à ce que l’air circule le mieux possible comme illustré.

Wall or obstructions

Mur, ou obstruction

Spacing 15 cm or more Dégagement de 15 cm ou plus

RX-778VBK

Front

Avant

Stand height 15 cm or more Hauteur du socle: 15 cm ou plus

Floor Plancher

Image 2

Contents RX-778VBK Mises en garde, précautions et indications diverses Table of Contents Front Panel Remote ControlParts Identification Getting Started Before Installation Connecting the FM and AM AntennasChecking the Supplied Accessories Connecting the front speakers Connecting the SpeakersBasic connecting procedure AM Antenna ConnectionsWhen you connect two sets of front speakers Connecting the subwoofer speakerCase 1 When you connect only one set of front speakers Audio component connections Connecting Audio/Video ComponentsAnalog connections DBS tuner Video component connectionsDVD player To composite video outputPlug the power cord into an AC outlet Connecting the Power CordPutting Batteries in the Remote Control Replace the coverBasic Operations Turning the Power On and Off StandbyFrom the remote control Selecting the Source to PlayATT. briefly while viewing Adjusting the VolumeSelecting the Front Speakers EtcAdjusting the Subwoofer Output Level Attenuating the Input SignalListening at Low Volume Loudness Muting the SoundSetting the Subwoofer Information Basic SettingsAdjusting the Front Speaker Output Balance Digital Input Digital in Terminal SettingSelecting the Analog or Digital Input Mode Showing the Text Information on DisplayCenter Delay Time Setting Setting the Speakers for the DSP ModesRear Delay appears on Display Front, Center, and Rear Speaker SettingRange COMP. Dynamic Range Compression appears on Display Frequency appears on the displayLFE ATT Low Frequency Effect Attenuator appears on Display Using the Sleep Timer Storing the Basic Settings Adjustments One Touch OperationAdjust the sound using the functions listed above Press ONE Touch OPERATION. OnetouchoperationReceiving Radio Broadcasts Using Preset TuningTuning in Stations Manually Tune in a preset station Assigning Names to Preset StationsSelecting the FM Reception Mode Turn Multi JOG to selectSelecting Your Favorite SEA Mode Using the SEA ModesCreating Your Own SEA Mode DAP modes Using the DSP Modes3D-PHONIC modes JVC Theater Surround Surround modesDolby Surround Dolby Digital and Dolby Pro Logic Rear Available DSP Modes According to the Speaker ArrangementFront Adjusting the 3D-PHONIC Modes Adjusting the DAP ModesAdjusting the Surround Modes Press Dolby Surround to Activate an appropriate Surround Mode PRO Logic or DolbyPress Test again to stop the test tone. Test Repeatedly until Theater orTo adjust the right rear speaker level, press Theater or DIG Theater appears on DisplayActivating the DSP Modes Press Menu Using the On-Screen MenusWhen you finish, press Exit Press % / Þto move to VisualPress %/ Þto move to Sound CONTROL, then press @/ # Press % / Þto move to Surround LEVEL, then press @/ #Press %/ Þto move to Sound CONTROL, then press @ / # Press %/ Þ/ @/ # to adjust the SEA mode as you wantPress SET to store the setting into the SEA Usermode Press %/ Þto move to SEA, then press @/ #Press % / Þto move To Tuner CONTROL, then press @/ # Press %/ Þto move To SETTING, then press @/ #Setting the Basic Setting Items Also see Assigning Names to Preset Stations Press %/ Þto move to Preset NAME, then press SETStoring the Preset Stations Also see Press %/ Þ/ @/ # to Move in front of a character you wantSame time Compu Link Remote Control SystemRemote Control through the Remote Sensor on the Receiver Automatic Source SelectionDisplaying the Disc Information on the TV screen Text Compu Link Remote Control SystemCD player MD recorder Disc Search Only for CD PlayerTo exit from the Disc information screen Press Text Display while CD or MD is selected as the sourceShowing the Disc Information on the TV Screen Disc Information screen appears on the TVPress %/ Þto move to Performer Then press SET Press Text Display while CD is selected as the sourcePress %/ Þto move to SEARCH, then Press SET Press SET againEntering the Disc Information Press %/ Þto move to Search Then press SETPress % / Þto move to Title Input Then press SET Search for a disc by its genrePress Text Display while MD is selected as the source Enter the disc title, referring to steps 3Press %/ Þto move to the genre you want, then press SET Press %/ Þto move to Title Input Then press SETIf the AV Compu Link terminal on the TV is AV Compu Link EX AV Compu Link Remote Control SystemIf the AV Compu Link terminal on the TV is RECEIVER/AMP One-Touch Video Play Automatic Selection of TV’s Input ModeAutomatic Power On/Off One-Touch DVD PlayTuner Operating JVC’s Audio/Video ComponentsSound control section Amplifier CD playerCassette deck To operate JVC’s video components using this remote controlTurntable MD recorderOperating Other Manufacturers’ Video Equipment Release TV/CATV/DBS PowerIf there are more than one code listed for your brand of TV Try to operate your TV by pressing TV/CATVIf there are more than one code listed for your brand Release VCR PowerTry to operate your VCR by pressing VCR Power Manufacturer CodesTroubleshooting Problem Possible Cause SolutionFM tuner IHF SpecificationsAmplifier AM tunerEN, FR 0599HIMMDWJEM