English
When playing a digital source through a digital terminal
Adjusting the Volume
•The DIGITAL SOURCE FORMAT lamps on the front panel indicate what type of the digital signal comes into the receiver.
|
| DOLBY DIGITAL: | |
DIGITAL SOURCE FORMAT | Lights up when Dolby Digital signals (see | ||
page 21) come in. | |||
DOLBY | LINEAR | ||
LINEAR PCM: | |||
DIGITAL | PCM | ||
|
| Lights up when Linear PCM signals come | |
|
| in. | |
•The signal indicators also light up on the display to indicate the incoming channel signals. (Only the indicators for the incoming signals light up.)
L: | Left front channel |
R: | Right front channel |
On the front panel:
To increase the volume, turn MASTER
VOLUME clockwise.
To decrease the volume, turn it counterclockwise.
•When you turn MASTER VOLUME rapidly, the volume level also changes rapidly.
•When you turn MASTER VOLUME slowly, the volume level also changes slowly.
From the remote control:
To increase the volume, press VOLUME +. To decrease the volume, press VOLUME
CAUTION:
MASTER VOLUME
–
+
VOLUME
L | C | R | C: | Center channel |
| LFE |
| LS: | Left rear channel |
LS | S | RS | RS: | Right rear channel |
|
|
| S: | Rear channel (monaural) |
|
|
| LFE: | Subwoofer channel |
Selecting different sources for picture and sound
You can watch picture from a video component while listening to
Always set the volume to the minimum before starting any source. If the volume is set at its high level, the sudden blast of sound energy can permanently damage your hearing and/or ruin your speakers.
Note:
The volume level can be adjusted within the range of “0” (minimum) to “90” (maximum).
Selecting the Front Speakers
sound from another component.
On the front panel:
1. Press SOUND SELECT (INPUT |
ATT.) briefly while viewing the |
picture from a video component |
SOUND SELECT
INPUT ATT.
On the front panel ONLY:
When you have connected two pairs of the front speakers, you can select which to use.
such as the VCR or DVD player, |
etc.
“SOUND SELECT” appears on the display.
Press SPEAKERS 1 or SPEAKERS 2 to select the speaker to use.
• Each time you press the button, the lamp on |
the respective button turns on and off. When |
the lamp on either button lights up, the |
SPEAKERS
12
2. Turn SOURCE SELECTOR to | SOURCE SELECTOR |
select the sound (except the TV |
|
sound), while the indication of the |
|
above step is still on the display. |
|
From the remote control:
Press one of the audio source selecting buttons (CD, TAPE/MD, PHONO, FM/AM), while viewing the picture from a video component such as the VCR or DVD player, etc.
Notes:
•Once you have selected a video source, pictures of the selected source are sent to the TV until you select another video source.
•When you select “TV SOUND” as the source, this function does not work.
respective speakers are activated. |
Note:
If you use any of the DSP modes other than the
10