ProForm PFTL49707.0 HOW to Fold and Move the Treadmill, HOW to Fold the Treadmill for Storage

Page 20

HOW TO FOLD AND MOVE THE TREADMILL

HOW TO FOLD THE TREADMILL FOR STORAGE

Before folding the treadmill, adjust the incline to the lowest position. If you do not do this, you may damage the treadmill when you fold it. Remove the key and unplug the power cord. CAUTION: You must be able to safely lift 45 lbs. (20 kg) to raise, lower, or move the treadmill.

1.Hold the metal frame firmly in the location shown by the arrow at the right. CAUTION: To decrease the possibility of injury, do not lift the frame by the plastic foot rails.

Make sure to bend your legs and keep your back straight as you raise the frame. Raise the frame about halfway to the vertical position.

2.Move your right hand to the position shown and hold the treadmill firmly. Using your left hand, pull the latch knob to the left and hold it. Raise the frame until the hole in the isola- tor is aligned with the latch pin, and then slowly release the latch knob. Make sure that the latch pin is fully inserted into the center of the isolator.

To protect the floor or carpet from damage, place a mat under the treadmill. Keep the treadmill out of direct sun- light. Do not leave the treadmill in the storage position in temperatures above 85° F (30° C).

HOW TO MOVE THE TREADMILL

Before moving the treadmill, convert it to the storage position as described above. Make sure that the latch pin is fully in- serted into the center of the isolator.

1.Hold a handrail and the frame and place one foot against one of the wheels.

2.Tilt the treadmill back until it rolls freely on the wheels. Carefully move the treadmill to the desired location. To re- duce the risk of injury, use extreme caution while moving the treadmill. Do not attempt to move the treadmill over an uneven surface.

3.Place one foot against a wheel, and carefully lower the tread- mill until it is resting in the storage position.

HOW TO LOWER THE TREADMILL FOR USE

Storage

Engaged

Latch

 

Isolator

 

Deck

 

Handrails

 

Wheels

1.Hold the upper end of the treadmill with your right hand. Pull the latch knob to the left and hold it. Pivot the frame downward past the latch pin and slowly release the latch knob.

2.Hold the metal frame firmly with both hands and lower it to the floor. CAUTION: Do not grip only the plastic foot rails or drop the frame to the floor. Bend your legs and keep your back straight.

20

Image 20
Contents Call TOLL-FREE QUESTIONS?Model No. PFTL49707.0 Serial No Table of Contents Important Precautions Page Before YOU Begin Assembly Latch Holes Wire Tie Large See the left inset drawing. Identify the two Outer side of the Frame Spacer facingBolt yet See the left inset drawing. Identify the outerStar Washers 19. Be careful not to pinch Upright Wire Front View Be careful not to pinch the wires. Next, threadNot tighten the Bolts yet Two 1/4 X 1/2 BoltsSide View View from Above Page PRE-LUBRICATED Walking Belt Operation and AdjustmentHOW to Plug in the Power Cord Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeMeasure your heart rate if desired Avoid moving your hands. When your pulseTurn on the fan if desired HOW to USE a Trainer Workout Select a trainer workoutHOW to Create a Custom Program Select a custom programHOW to USE a Custom Program Information Mode HOW to USE the DumbbellsHOW to Fold and Move the Treadmill HOW to Fold the Treadmill for StorageHOW to Move the Treadmill HOW to Lower the Treadmill for USETop TroubleshootingProblem The power turns off during use Problem The walking belt slows when walked on Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart LIST-Model No. PFTL49707.0 Key No. Qty DescriptionExploded Exploded Drawing B-Model No. PFTL49707.0 R0707A Exploded Drawing C-Model No. PFTL49707.0 Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT Ordering Replacement PartsLimited Warranty