Assembly

To hire an authorized service technician to assemble the treadmill, call toll-free 1-800-445-2480. Assembly requires two persons. Set the treadmill in a cleared area and remove the packing materials; do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, lubricant may be transferred to the top of the walking belt or to the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, wipe it off with a soft cloth and mild, non-abrasive cleaner.

Assembly requires the included hex keys and your own Phillips screwdriver , rubber

mallet , adjustable wrench , and wire cutters .

Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of the manual. The number after the parentheses shows the quantity needed for assembly. Note: If a part is not in the parts bag, check to see if it is preat- tached to one of the parts to be assembled. Extra hardware may be included. To avoid damaging plastic parts, do not use power tools for assembly.

5/16" x 2 1/4" (20)–4	3/4" Screw (2)–6	Wheel Spacer	1/4" Star
		(44)–4	Washer (21)–2
	1/2" Ground
	Screw (11)–2
			5/16" Star
3/8" x 2 1/4" Bolt (40)–6		3/8" Washer	Washer (19)–4
		3/8" Washer
	1/4" x 1/2"	(33)–2
	1/4" x 1/2"
	Bolt (22)–4
			3/8" Star
3/8" x 2 3/4" Bolt (32)–2		3/8" Nut (47)–4	Washer (39)–4

1.Orient the Base (48) as shown.

Identify the Right Upright (36), which has a large hole near the lower end.

Orient the Right Upright (36) as shown, and attach it to the Base (48) with two 3/8" x 2 1/4" Bolts (40) and two 3/8" Star Washers (39); do not tighten the Bolts yet.

Large

Hole