ProForm PFTL69211 user manual See HOW to Turn on the Power above, HOW to USE the Manual Mode

HOW TO TURN ON THE POWER

111 Plug in the power cord (see page 8).

El Locate the on/off

ra switch near the power

cord. Move the on/offOn Position Al

switch to the on posi- tion.

Li Stand on the foot pads of the treadmill. Find the CI clip attached to the key (see the drawing on page

9)and slide the clip onto the waistband of your clothes. Next, insert the key into the console. After a moment, the displays and various indicators will light. Test the clip by carefully taking a few steps backward until the key is pulled from the console. If the key is not pulled from the con- sole, adjust the position of the clip.

HOW TO USE THE MANUAL MODE

El Insert the key fully into the console.

See HOW TO TURN ON THE POWER above.

Ei Select the manual mode.

When the key is in- serted, the manual

mode will be selectedt7T°.; 101111,-A,V.1=

Each time a button is pressed, the speed setting will change by 0.1 mph; if a button is held down, the speed setting will change in increments of 0.5 mph. To change the speed setting quickly, press the Quick Speed buttons. Note: The console can display speed and distance in either miles or kilometers. For simplicity, all instructions in this section refer to miles.

During the first few minutes of using the treadmill, inspect the alignment of the walking belt, and align the walking belt if necessary (see page 24).

To stop the walking belt, press the Stop button. The Time/Incline/Segment Time display will begin to flash. To restart the walking belt, press the Start button or the Speed A button.

4 Change the incline of the treadmill as desired.

To change the incline of

the treadmill, press the

r

Incline buttons. Each time a button is pressed, the

TIME INCLINE SEG.TIME

incline will change by 0.5%. Note: After the but-

tons are pressed, it may take a moment for the treadmill to reach the selected incline setting.

U Follow your progress with the LED track and the displays.

The LED Track—When
the manual mode or the	0000000
iFIT.com mode is se-
	0000000
lected, the program dis-	0000000
	0000000

play will show an LED ,0000000,

and the Manual Control

,

track representing 1/4

IzIANUOL,1,1713i,

indicator will light. If a program has been

selected, press the Program button repeatedly to reselect the manual mode.

rl Press the Start button or the Speed A button to

mile. As you exercise,

the indicators around the track will light in sequence until you have completed 1/4 mile. A new lap will then begin.

Calories/Fat Calories/

CJI start the walking belt.

Heart Rate display—

HEART RATE

A moment after the but- ton is pressed, the

walking belt will begin to—II al move at 1 mph. Hold

SPEED MIN/MILE (km)

the handrails and begin walking. As you exer-

cise, change the speed of the walking belt as de- sired by pressing the Speed V and A buttons.

This display shows the	0
	• •,— •
approximate numbers of
calories and fat calories	CALORIES FAT CALS.
you have burned (see

FAT BURNING on page 25). The display will change from one number to the other every few seconds, as shown by the indicators in the dis- play. The display will also show your heart rate when you use the pulse sensor (refer to step 6 on page 11) or the optional chest pulse sensor (refer to page 20).

10