ProForm 831.293201 user manual Problem The walking belt slows when walked on, Unplug Power Cord

With the help of a second person, carefully raise the Upright Base (97) as shown. Carefully pivot the Hood (123) off.

Locate the Reed Switch (22) and the Magnet (19) on

the left side of the Pulley (18). Turn the Pulley until the

Magnet is aligned with the Reed Switch. Make sure that the gap between the Magnet and the Reed

Switch is about 1/8”. If necessary, loosen the Screw

(23)and move the Reed Switch slightly. Retighten the Screw. Reattach the Hood, and run the treadmill for a few minutes to check for a correct speed reading.

		97
	123
1/8”		18
22
	23	19
Top
View

PROBLEM: The walking belt slows when walked on

SOLUTION: a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 8.

b. If the walking belt is overtightened, treadmill perfor-			b
mance may decrease and the walking belt may be-
come damaged. Remove the key and		UNPLUG THE	2”–3”
POWER CORD	. Using the allen wrench, turn both
rear roller adjustment bolts counterclockwise, 1/4 of a
turn. When the walking belt is properly tightened, you
should be able to lift each side of the walking belt 2 to
3 inches off the walking platform. Be careful to keep
the walking belt centered. Plug in the power cord, in-
sert the key, and run the treadmill for a few minutes.			Rear Roller Adjustment Bolts
Repeat until the walking belt is properly tightened.
c. If the walking belt still slows when walked on, please call toll-free 1-800-4-MY-HOME				® (1-800-
469-4663).

PROBLEM: The walking belt is off-center or slips when walked on
SOLUTION:	a. If the walking belt is off-center,		first remove the key
	and UNPLUG THE POWER CORD		. If the walking
	belt has shifted to the left,		use the allen wrench to
	turn the left rear roller bolt clockwise 1/2 of a turn;			if
	the walking belt has shifted to the right,			turn the
	bolt counterclockwise 1/2 of a turn. Be careful not to
	overtighten the walking belt. Plug in the power cord,
	insert the key, and run the treadmill for a few minutes.
	Repeat until the walking belt is centered.
	b. If the walking belt slips when walked on,			first re-
	move the key and	UNPLUG THE POWER CORD		.

Using the allen wrench, turn both rear roller bolts clockwise, 1/4 of a turn. When the walking belt is cor- rectly tightened, you should be able to lift each side of the walking belt 2 to 3 inches off the walking platform. Be careful to keep the walking belt centered. Plug in

the power cord, insert the key, and carefully walk on the treadmill for a few minutes. Repeat until the walk- ing belt is properly tightened.

a

b

23