JVC RX-E100RSL Press Control 3or 2 to select AUTO1 or, AUTO2 or Manual, To cancel Auto Surround

ON : • If multichannel signals come in, an appropriate Surround mode will be turned on.

•If Dolby Digital 2 channel or DTS 2 channel signals come in, “STEREO” will be selected.

•If Linear PCM signals come in, nothing will change.

OFF : Select this to deactivate Auto Surround.

Notes:

•This function does not take effect in the following cases:

–While playing an analogue source.

–While selecting “DGTL D.D.” or “DGTL DTS” as the fixed digital input mode (see pages 13 and 14).

•If Surround mode is automatically activated by Auto Surround, another DSP mode in use will be canceled temporarily. When multichannel digital signals stop coming in, the selected surround mode is canceled, and the previous DSP mode resumes.

•If you press SURROUND ON/OFF or DSP MODE with Auto Surround activated, Auto Surround will be canceled temporarily for the currently selected source.

Auto Surround setting will be restored in the following cases:

–When you turn off and on the unit,

–When you change the source, and

–When you reset “AUTO SR” to “ON” again.

2Press CONTROL ° (or 5) repeatedly until “MODE” (with the current setting) * appears on

the display.

CONTROL

OGIC

AUTO
ATT	VOL

*“MANUAL” is the initial setting. If you have already changed the setting, the other mode will be shown.

3Press CONTROL 3(or 2) to select “AUTO1” (or, “AUTO2” or “MANUAL”).

• Each time you press the button, TV Direct mode turns change

as follows:

CONTROL
ANALOG	L	C	R	PRO LOGIC
LPCM	SUBWFR LFE			DSP
DOLBY D	LS	S	RS	DGTL AUTO	VOL
DTS				INPUT ATT

Basic Settings

To cancel Auto Surround

Repeat steps 1 and 2, then select “OFF” in step 3.

Setting the TV Direct mode

You can enjoy switching TV Direct automatically by turning on/off the video components connected to the unit with SCART cable — TV Direct auto mode.

•This function takes effect only when the video components and TV are connected to this unit with SCART cables.

•This function takes effect to the following sources — DVD, STB, and VCR.

Before you start, remember...

There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

1Press SETTING.

SETTING	The CONTROL buttons now work for basic
	settings.

AUTO1 : When a video component is turned on while the unit is on, the unit selects the video component as the source automatically.

AUTO2 : • When a video component is turned on

–while the unit is off, the unit changes the mode into TV Direct and selects the video component as the source automatically.

–while the unit is on or TV Direct is activated, the unit selects the video component as the source automatically.

• When a video component is turned off

–while TV Direct is activated or the unit is on with one of the video components selected,

the unit selects the previously selected video component as the source automatically. (If all the video components are turned off, the unit will be turned off automatically.)

MANUAL : Select this to use TV Direct manually.

Note:

When a VCR is selected as the source, AUTO1 or AUTO2 does not work by turning on the VCR but by starting playback.

19