If you purchase the optional chest pulse sensor (see page 25), follow the steps below to install the re- | ||
ceiver included with the chest pulse sensor. |
|
|
1. Make sure that the power cord is unplugged. | 1 |
|
Remove the indicated #8 x 3/4" Screws (4) from |
| |
the Pulse Receiver Cover (70) on the back of the |
|
|
Console (66). |
|
|
|
| 66 |
|
| 70 |
|
| 4 |
2. Next, hold the receiver so that the small | 2 |
|
cylinder is oriented as shown. Attach the re- | Small Screws | |
ceiver to the Pulse Receiver Cover (70) with the |
| |
two included small screws. |
| Receiver |
|
| Cylinder |
|
| 70 |
3.Connect the wire on the receiver to the wire ex- tending from the Console (66). Make sure that no wires are pinched. Reattach the Pulse Receiver Cover (70) to the Console with the two #8 x 3/4" Screws (4). Discard the other wires in- cluded with the receiver.
3 |
|
66 Tab | Wires |
| 70 |
| 4 |
12