Before operating the television, you must connect an antenna or a 75 ohm CATV cable to the 75 ohm ter- minal or the AV wire to the audio/video input jack. Note: Use a CATV cable to connect to an external source such as a cable box, satellite TV box, VCR, or analog cable. No CATV cable, antenna, or adapter is included.
HOW TO CONNECT AN ANTENNANote: Due to an FCC requirement, analog signals will no longer be broadcast over the air after February 17, 2009. If you wish to view television signals through an antenna after that date, you must have an antenna ca- pable of receiving digital signals. Cable television will not be affected.
Screwdriver | 300 |
| Ohm Flat |
| Wire |
300 to 75 Ohm Adapter
300 to 75 Ohm Adapter
75 Ohm
Terminal
HOW TO CONNECT AN EXTERNAL SOURCE USING A CATV CABLE
1.Connect one end of a 75 ohm CATV cable to the 75 ohm output jack on your external source.
2.Plug in the power cord of your external source. See your external source userʼs manual for proper grounding instructions.
3.Connect the 75 ohm CATV cable to the 75 ohm terminal on the treadmill frame near the power cord. See the drawing at the left.
HOW TO CONNECT A VCR OR DVD PLAYER | |
USING THE AV WIRE |
|
1. Connect the three- |
|
pronged end of the | 88 |
AV Wire (88) to your | |
VCR or DVD player. |
|
2.Plug in the power cord of your VCR or DVD player. See your VCR or DVD player userʼs manual for proper grounding instructions.
3.Connect the AV Wire to the audio/video input jack on the treadmill frame near the power cord.
13