ProForm PFTL14008.0 user manual HOW to Turn on the Power, HOW to USE the Manual Mode

Page 16
Key Clip
Reset
Position

HOW TO TURN ON THE POWER

IMPORTANT: If the treadmill has been exposed to cold temperatures, allow it to warm to room tem- perature before turning on the power. If you do not do this, you may damage the console displays or other electrical components.

Plug in the power cord (see page 14). Next, locate the reset/off circuit breaker on the treadmill frame near the power cord. Make sure that the circuit breaker is in the “reset” position.

IMPORTANT: The console features a display demo mode, designed to be used if the treadmill is dis- played in a store. If the displays light as soon as you plug in the power cord and switch the reset/off circuit breaker to the reset position, the demo mode is turned on. To turn off the demo mode, hold down the Stop button for a few seconds. If the displays remain lit, see THE INFORMATION MODE on page 25 to turn off the demo mode.

Next, stand on the foot rails of the treadmill. Locate the clip attached to the key (see the drawing at the right), and slide the clip securely onto the waistband

of your clothes. Then, insert the key into the console. After a moment, the displays will light. IMPORTANT:

In an emergency situation, the key can be pulled from the console, causing the walking belt to slow to a stop. Test the clip by carefully taking a few steps backward; if the key is not pulled from the console, adjust the position of the clip. IMPORTANT: If there is a sheet of clear plastic on the face of the console, remove the plastic. To pre- vent damage to the walking platform, wear clean athletic shoes while using the treadmill. The first time the treadmill is used, observe the alignment of the walking belt, and center the walking belt if nec- essary (see page 29).

Note: The console can display speed and distance in either miles or kilometers. To find out which unit of measurement is selected or to change the unit of mea- surement, see THE INFORMATION MODE on page 25. For simplicity, all instructions in this section refer to miles.

HOW TO USE THE MANUAL MODE

1.Insert the key into the console.

See HOW TO TURN ON THE POWER at the left.

2.Select the manual mode. Each time the key is in- serted, the manual mode will be selected. If you have selected a workout, press any of the workout buttons (Weight Loss, Aerobic Fitness,

Performance, or Custom) repeatedly until a track appears in the matrix.

3.Start the walking belt and adjust the speed.

To start the walking belt, press the Start button, the Speed increase button, or one of the speed but- tons numbered 1 to 12.

If you press the Start button or the Speed increase button, the walking belt will begin to move at 1 mph. As you exercise, change the speed of the walking belt as desired by pressing the Speed in- crease and decrease buttons. Each time you press a button, the speed setting will change by 0.1 mph; if you hold down the button, the speed setting will change in increments of 0.5 mph. If you press one of the numbered speed buttons, the walking belt will gradually change speed until it reaches the se- lected speed setting.

To stop the walking belt, press the Stop button. To restart the walking belt, press the Start button, the Speed increase button, or one of the numbered speed buttons.

4.Change the incline of the treadmill as desired. To change the incline of the treadmill, press the Incline increase and decrease buttons or one of the incline buttons numbered 0 to 12.

Each time you press the Incline increase or de- crease button, the incline will change by 0.5%. If you press one of the numbered incline buttons, the incline will gradually change until it reaches the se- lected incline setting. Note: After you press the but- tons, it may take a moment for the treadmill to reach the selected incline setting.

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents QUESTIONS? Model No. PFTL14008.0 Serial NoMon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT On the WEBTable of Contents Important Precautions Page Power Lines Ground Standoff Service Clamp Before YOU Begin Assembly Bolts yet Ful not to pinch the Upright Wire HarnessBe careful not to pinch the Cables Left Right Console Assembly Wire75 Tie Console Assembly Wire Tie Console assembly as described above Attach the Left Upright Sleeve not shown toSmall Screws HOW to Connect a VCR or DVD Player HOW to Connect AN External Source Using a Catv CableUsing the AV Wire HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the Console HOW to Turn on the Power HOW to USE the Manual ModeStart the walking belt and adjust the speed Insert the key into the consoleFollow your progress with the displays. The matrix-When you Turn on the fan if desiredSelect a preset workout HOW to USE a Preset WorkoutStart the walking belt HOW to Create a Custom Workout Select a custom workoutHOW to USE a Custom Workout Adjust the volume Scan for television channelsSelect a television source Select the desired channelHOW to USE the Remote Control HOW to Replace the Batteries in the Remote ControlHOW to Adjust the Television Settings Scan and save channels Exit the MenuHOW to USE the Sound System Information ModeOptional Chest Pulse Sensor HOW to Fold and Move the Treadmill HOW to Move the TreadmillHOW to Lower the Treadmill for USE Troubleshooting Problem The power turns off during useImportant The treadmill is not Compatible with GFCI-equipped outletsProblem The walking belt slows when walked on Unplug the Power CORD. If the walking beltTop Ing belt has shifted to the right, turn the left idlerKey and Unplug the Power CORD. Using Problem Television reception is poorProblem The remote control does not function correctly Problem The television is not receiving a signalProblem The volume cannot be turned up Problem The television needs to be cleanedExercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart LIST-Model No. PFTL14008.0 Qty DescriptionDescription Key No. Qty 3355 Exploded Drawing B-Model No. PFTL14008.0 R0109A Exploded Drawing C-Model No. PFTL14008.0 R0109A Exploded Drawing D-Model No. PFTL14008.0 R0109A Exploded Drawing E-Model No. PFTL14008.0 R0109A Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., LOGAN, UT

PFTL14008.0 specifications

The ProForm PFTL14008.0 is a state-of-the-art treadmill designed for fitness enthusiasts seeking a balance of performance, technology, and convenience. This model boasts an array of features that cater to varied workout needs, making it an exceptional choice for both beginners and seasoned athletes.

One of the standout characteristics of the PFTL14008.0 is its powerful motor. The treadmill is equipped with a robust 2.0 CHP motor, which provides ample power for a variety of workouts, including running, jogging, and walking. This motor ensures consistent performance across all speeds, allowing users to reach their fitness goals while enjoying a smooth experience.

The running surface of the ProForm PFTL14008.0 is another significant feature. It offers a spacious 16 x 50-inch deck, providing plenty of room for users to stride comfortably. Additionally, the deck is cushioned with ProShox technology, which helps reduce impact on joints, making it ideal for both high-impact workouts and longer training sessions.

In terms of technological integration, the treadmill is equipped with a 5-inch LCD display that provides essential information such as speed, time, distance, and calories burned. This information is crucial for monitoring progress and motivation. The ProForm PFTL14008.0 also features quick-speed buttons that allow users to adjust their workout intensity with ease.

Connectivity options further enhance the user experience. The treadmill is iFit compatible, offering access to personalized training programs, global workouts, and real-time coaching. This technology keeps workouts engaging and tailored to individual fitness levels. Moreover, users can easily connect their devices through Bluetooth, allowing them to listen to music or follow along with fitness videos.

Safety features have been prioritized in the design of the ProForm PFTL14008.0. The treadmill includes a safety key that stops the machine if the user falls, ensuring a safer workout experience. With built-in transport wheels, moving the treadmill is effortless, making it a versatile addition to any home gym.

Durability is another hallmark of the ProForm PFTL14008.0, which is built to withstand rigorous use over time. The frame is sturdy and designed to accommodate various user weights and heights, making it an excellent investment for family use.

In summary, the ProForm PFTL14008.0 treadmill combines power, technological advancements, and thoughtful design, catering to a range of workout preferences while providing a safe, effective, and enjoyable fitness experience. Whether for casual exercise or serious training, this treadmill is engineered to support users on their fitness journey.
Top Page Image Contents