ProForm PFTL39908.0 manual Knob Spring Collar Large Hole Pin

Page 11

12.See the lower drawing. Position the Uprights (53, 54) so that the Frame (51) is centered be- tween them.

See the upper drawing. Firmly tighten the two M10 x 60mm Bolts (1) and the four M10 x 75mm Bolts (2). Be careful not to overtighten the M10 x 60mm Bolts.

13.Attach the Latch Housing (48) to the Left Upright (53) with two M4.2 x 19mm Screws (10); start both Screws before tightening either of them. Make sure that the large hole in the Latch Housing is on the indicated side. Locate the Latch Pin Assembly (24). Remove the knob from the pin. Make sure that the collar and the spring are on the pin. (Note: If there are two collars, place one on each side of the spring.) Insert the pin into the Latch Housing (48). Then, tighten the knob onto the pin.

12		1
		2
	51
	Top View
54	51	53

13
24	48	53
Knob		Spring
10		Collar
Large Hole		Pin

14.Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex keys in a secure place. One hex key is used to adjust the walking belt (see page 20). To protect the floor or carpet, place a mat under the treadmill.

11

Image 11

Contents On the WEB QUESTIONS?Model No. PFTL39908.0 Serial No Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MTTable of Contents Important Precautions Page For your benefit, read this manual carefully before Before YOU BeginExtra hardware may be included AssemblyMake sure that the power cord is unplugged Do not tighten the Bolts yet See the upper inset drawing. Locate the wireOrient the Left Upright 53 so the indicated Small holes are on top as shown. AttachSee the left inset drawing. Identify the outer See the left inset drawing. Identify the twoOuter side of the Frame Spacer facing Right Upright Washer 9 do not tighten the Bolt yet Top ViewShould slide together easily and snap into Assembly 91. Make sure that no wires areWire. See the inset drawing. The connectors Again. if the Connectors are not CONPage Knob Spring Collar Large Hole Pin PRE-LUBRICATED Walking Belt Operation and AdjustmentHOW to Plug in the Power Cord Features of the Console Console DiagramStart the walking belt HOW to Turn on the PowerHOW to USE the Manual Mode Insert the key into the consoleTurn on the fan if desired Measure your heart rate if desiredSeconds- avoid moving HOW to USE a Speed Workout Information Mode HOW to USE the Sound SystemMake sure that the audio wire is fully plugged HOW to Lower the Treadmill for USE HOW to Fold and Move the TreadmillHOW to Move the Treadmill Compatible with GFCI-equipped outlets TroubleshootingProblem The power turns off during use Belt has shifted to the right, turn the left idler roller Problem The walking belt slows when walked onUnplug the Power CORD. If the walking belt Exercise Frequency Exercise GuidelinesExercise Intensity Workout GuidelinesKey No. Qty Description Part LIST-Model No. PFTL39908.0105 Cage Nut Blue Wire, 2F 106 107 Isolator Userʼs Manual Exploded Drawing A-Model No. PFTL39908.0 Exploded Drawing B-Model No. PFTL39908.0 R0908A Exploded Drawing C-Model No. PFTL39908.0 R0908A Exploded Drawing D-Model No. PFTL39908.0 R0908A Icon Health & Fitness, Inc., 1500 S W., Logan, UT Ordering Replacement PartsLimited Warranty