Orient the Left Upright 53 so the indicated

2. Have a second person hold the Base (52) in the	2
position shown.	2
Identify the Left Upright (53) (the Right Upright
[54] has a large hole near the lower end).	Small		54
Orient the Left Upright (53) so the indicated	Small
Orient the Left Upright (53) so the indicated	Holes
small holes are on top as shown. Attach the
Left Upright to the Base (52) with two M10 x	53		Large	2
75mm Bolts (2) and two M10 Star Washers (9);	53		Large	2
do not tighten the Bolts yet.			Hole
Attach the Right Upright (54) to the Base (52)		9	52	9
in the same way.		9	52	9
			2
3. Attach each Extension Leg (45) to the Base (52)	3
with two M8 x 58mm Bolts (13), two M8.5	3			45
Washers (32), and two Extension Leg Nuts (43).				45
Note: The heads of the wheel bolts should be
on the outside of the Extension Legs.	Bolt Head
Lower the Base (52) so that it is flat on the floor.	Bolt Head	13		43
Lower the Base (52) so that it is flat on the floor.	45	13	32	43
			32
	13	43	52
	32
4. Position the Base (52) as close to the front of the	4
treadmill as possible, as shown.	4	39
See the upper inset drawing. Locate the wire		39
tie in the lower end of the Right Upright (54). Tie			39	54
the wire tie securely around the end of the Wire			39	54
Harness (39). Then, locate the other end of the
wire tie in the upper end of the Right Upright.		54		Wire Tie
Pull the upper end of the wire tie until the Wire		54		Wire Tie
Harness is extending from the upper end of the	52
Right Upright. Secure the Wire Harness to the	52
Right Upright so that it will not fall inside.
See the lower inset drawing. Press the indi-
cated Grommet (49) into the Right Upright (54).				4954
				4954
	7

Orient the Left Upright (53) so the indicated

small holes are on top as shown. Attach the

do not tighten the Bolts yet.

Attach the Right Upright (54) to the Base (52)

in the same way.

on the outside of the Extension Legs.

See the upper inset drawing. Locate the wire

See the lower inset drawing. Press the indi-