ProForm PFTL39908.0 manual Assembly, Extra hardware may be included

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition. If there is lubricant on top of the walk- ing belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included hex keys		and your own Phillips screwdriver	.	,
adjustable wrench	, scissors	, and rubber mallet

Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number after the parentheses is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it is preattached to one of the parts to be assembled. To avoid damaging plastic parts, do not use power tools for assembly.

Extra hardware may be included.

M5 Star	M8 Star	M8.5 Washer	M10 Star	M10 Flat Washer
Washer (7)–2	Washer (5)–6	(32)–4	Washer (9)–6	(14)–2
Extension Leg Nut	M4 x 10mm	M4.2 x 19mm	M5 x 16mm	#8 x 1" Tek Screw
(43)–4	Ground Screw (84)–1	Screw (10)–6	Screw (85)–2	(26)–6
M8 x 15mm	M8 x 58mm Bolt (13)–4		M10 x 60mm Bolt (1)–2
Bolt (8)–6
	M10 x 75mm Bolt (2)–4

1.	Make sure that the power cord is unplugged.	1		26		52		26
	Position the Base (52) and the two Extension							63
	Legs (45) upside-down as shown.			63					26
	Attach six Base Pads (63) to the Base (52) and
			26				45		63
	the Extension Legs (45) with six #8 x 1" Tek							26
	Screws (26).		63			63
					26			63
		6