ProForm PFTL39908.0 manual

Page 4
19. The treadmill is capable of high speeds. Adjust the speed in small increments to avoid sudden jumps in speed.
20. Never leave the treadmill unattended while it is running. Always remove the key, unplug the power cord, and switch the reset/off cir- cuit breaker to the off position when the treadmill is not in use. (See the drawing on page 5 for the location of the circuit breaker.)
21. Do not attempt to raise, lower, or move the treadmill until it is properly assembled. (See ASSEMBLY on page 6 and HOW TO FOLD AND MOVE THE TREADMILL on page 18.) You must be able to safely lift 45 lbs. (20 kg) to raise, lower, or move the treadmill.
22. When folding or moving the treadmill, make sure that the storage latch is holding the frame securely in the storage position.

23. Do not change the incline of the treadmill by placing objects under the treadmill.

24. Inspect and properly tighten all parts of the treadmill regularly.

25. Never drop or insert any object into any opening on the treadmill.

26. This treadmill is intended for in-home use only. Do not use this treadmill in a commer- cial,DANGER:rental, or institutional setting.

27.Always unplug the power cord immediately after use, before cleaning the treadmill, and before performing the main- tenance and adjustment procedures de- scribed in this manual. Never remove the motor hood unless instructed to do so by an authorized service representative. Servicing other than the procedures in this manual should be performed by an authorized service representative only.

SAVE THESE INSTRUCTIONS

4

Image 4
Contents QUESTIONS? Model No. PFTL39908.0 Serial NoMon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT On the WEBTable of Contents Important Precautions Page Before YOU Begin For your benefit, read this manual carefully beforeMake sure that the power cord is unplugged AssemblyExtra hardware may be included See the upper inset drawing. Locate the wire Orient the Left Upright 53 so the indicatedSmall holes are on top as shown. Attach Do not tighten the Bolts yetSee the left inset drawing. Identify the two Outer side of the Frame Spacer facing Right UprightWasher 9 do not tighten the Bolt yet Top View See the left inset drawing. Identify the outerAssembly 91. Make sure that no wires are Wire. See the inset drawing. The connectorsAgain. if the Connectors are not CON Should slide together easily and snap intoPage Knob Spring Collar Large Hole Pin HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeInsert the key into the console Start the walking beltSeconds- avoid moving Measure your heart rate if desiredTurn on the fan if desired HOW to USE a Speed Workout Make sure that the audio wire is fully plugged HOW to USE the Sound SystemInformation Mode HOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Lower the Treadmill for USE Problem The power turns off during use TroubleshootingCompatible with GFCI-equipped outlets Unplug the Power CORD. If the walking belt Problem The walking belt slows when walked onBelt has shifted to the right, turn the left idler roller Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart LIST-Model No. PFTL39908.0 Key No. Qty Description105 Cage Nut Blue Wire, 2F 106 107 Isolator Userʼs Manual Exploded Drawing A-Model No. PFTL39908.0 Exploded Drawing B-Model No. PFTL39908.0 R0908A Exploded Drawing C-Model No. PFTL39908.0 R0908A Exploded Drawing D-Model No. PFTL39908.0 R0908A Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT