ProForm PFTL312040 user manual Side View

Page 7

2.Identify the Right Upright (62), which has a large round hole near the lower end, and the Left Upright (9). See inset drawing 2a. Make sure that there are two U-Nuts (124) in the lower end of each Upright.

Straighten the Wire Harness (21), and feed it into the lower end of the Right Upright (62) and out of the upper end. Next, slide the indicated slot in the Right Upright onto the right Upright Lock Bracket (125) (see drawing 2b). Slide the Right Upright down until it reaches the Base (11). Make sure that the Wire Harness is not pinched. Finger tighten two 5/16” x 3” Bolts (123) with two 5/16” Star Washers (122) into the Base and the Right Upright.

With the help of a second person, tip the treadmill onto its other side. Attach the Left Upright (9) as described above. (Note: There is not a wire harness on the left side.) Attach the other Wheel (not shown) to the Base

(11)as described in step 1.

3.With the help of a second person, raise the Right Upright

(62)and the Left Upright (not shown) to the vertical posi- tion. Open part bag B. Identify the Right Handrail (47), which has a large hole in the left side. Remove any plas- tic ties from the rectangular bracket on the Right Handrail. Feed the Wire Harness (21) up into the bracket and out of the large hole in the left side. (Note: It may be helpful to use needlenose pliers to pull the Wire Harness out of the large hole.) Press a Handrail Cap (41) onto the lower end of the Right Handrail as shown.

Insert the bracket on the Right Handrail (47) into the top of the Right Upright (62) so the Handrail Cap (41) is rest- ing against the Right Upright. Attach the Right Handrail and the Handrail Cap with three 1” Bolts (8), three 1/4” Washers (39), and two 1/4” Star Washers (111) as shown. Do not tighten the Bolts yet.

Attach the Left Handrail (not shown) as described above. Note: There is not a wire harness on the left side.

4.Set the Crossbar (34) on the brackets on the Handrails (1, 47). Attach the Crossbar with two Crossbar Screws (53). Do not tighten the Crossbar Screws yet.

Open part bag C. Attach the end of the ground wire to the small hole in the side of the Right Handrail (47) with a Silver Ground Screw (104).

2

 

62

 

Slot

9

21 Hole

 

125

 

11

 

 

122

123

2a

9, 62

2b

125

Side

View

124

11

3

21

 

Large

 

Hole

8

Bracket

39

 

47

111

 

8

111

39

 

39

41

 

8

62

 

4

 

1

Ground

53

Wire

 

104

34

 

53

 

47

 

7

Image 7
Contents Model No. PFTL312040 Serial No QUESTIONS?Customer HOT Line Table of Contents Important Precautions Page Right Side Before YOU BeginBack Make sure that the power cord is unplugged AssemblySide View Inserted PROPERLY, the Console MAY be Damaged When the Power is Turned onSee . Firmly tighten the 1 Bolts HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt STEP-BY-STEP Console Operation Console DiagramInsert the key fully into the console Whenkey. you are finished exercising, remove Change the incline of the treadmill as desiredFollow your progress with the three displays Time/Distance Measure your heart rate if desiredHOW to USE the Upper Body Arms HOW to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Lower the Treadmill for USE HOW to Move the TreadmillProblem The power turns off during use TroubleshootingTop View Problem ONE of the Upper Body Arms Squeaks During USE Problem The walking belt slows when walked onExercise Frequency Conditioning GuidelinesExercise Intensity Workout GuidelinesSuggested Stretches Page Remove this Exploded Drawing and Part List from the Manual Key Qty Description Part LIST-Model No. PFTL312040PFTL312040 Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT