5. Place the Console Base (46) on the Right Handrail (47) |
and the Left Handrail (not shown). Attach the Console |
Base with four 3/4” Screws (13) (only two Screws are |
shown). Do not tighten the Screws yet. |
Insert the Wire Harness (21) through the two indicated |
plastic ties on the Console Base (46). Next, insert the |
Wire Harness up through the opening beside the Console |
Cover (96). Make sure that the Console Cover is securely |
attached to the Console Base. |
See the inset drawing. Look at the top of the Console |
Base (46). Insert the Wire Harness (21) through the plas- |
tic tie on top of the Console Base. |
6. Hold the Console (10) near the Console Base (46). |
Touch the Right Handrail (47) to discharge any static. |
See the inset drawing. Find the |
end of the Wire Harness (21). Insert the connector into |
the red socket beneath the console. The connector |
should slide easily into the socket and snap into |
place. If the connector does not slide easily and snap |
into place, turn the connector and then insert it. Insert the |
sole in the same way. |
Insert the excess Wire Harness (21) down through the |
opening in the Console Base (46 [see the inset drawing |
in step 5]). Securely tighten the plastic tie on top of |
the Console Base to prevent the Wire Harness from |
slipping. Then, cut off the end of the plastic tie. |
Make sure that the connectors and wires appear as |
shown at the right. IF THE CONNECTORS ARE NOT |
INSERTED PROPERLY, THE CONSOLE MAY BE |
DAMAGED WHEN THE POWER IS TURNED ON. |
5 | 46 |
|
|
| |
|
| 21 |
|
| 96 |
| Ties |
|
13 | 47 |
|
|
| |
|
| 21 |
|
| Tie |
|
| 46 |
6 |
|
|
| 21 | 10 |
Ties |
| 46 |
|
|
|
| 13 |
|
|
|
|
|
| 13 |
|
|
|
| 97 |
|
|
|
| |||
47 |
|
|
|
|
|
|
|
|
| |
|
|
|
|
| ||||||
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
See drawing 6a. Press the Bookrack (90) onto the Console |
Base (46) in the location shown. |
Set the Console (10) on the Console Base (46). Insert |
the excess Wire Harness (21) into the large hole in the |
side of the Right Handrail (47). Securely tighten the |
plastic ties on the bottom of the Console Base to |
prevent the Wire Harness from slipping. Then, cut off |
the ends of the plastic ties. |
21
6a
3-wire 5-wire
Attach the Console (10) to the Console Base (46) with four |
3/4” Screws (13) and two 1/2” Silver Screws (97). Start all |
six Screws before tightening them; do not over- |
tighten the Screws. |
90
46
8