ProForm PATL50707.0 user manual Console Diagram, Features of the Console, HOW to Turn on the Power

Page 13

CONSOLE DIAGRAM

Key

Note: If there are thin sheets of plastic on the console, remove the plastic.

Clip

FEATURES OF THE CONSOLE

The treadmill console offers a selection of features designed to make your workouts more effective.

While the manual mode of the console is selected, the speed and incline of the treadmill can be changed with the touch of a button. As you exercise, the displays will provide continuous exercise feedback. You can even measure your heart rate using the built-in pulse sensor.

The console also offers six speed workouts. Each workout automatically controls the speed of the tread- mill as it guides you through an effective workout.

To use the manual mode of the console, follow the steps beginning on page 14. To use a speed workout, see page 16.

Note: To prevent damage to the walking platform, always wear clean athletic shoes while using the treadmill. During the first few minutes that the treadmill is used, inspect the alignment of the walk- ing belt, and center the walking belt if necessary (see page 20).

HOW TO TURN ON THE POWER

IMPORTANT: If the treadmill has been exposed to cold temperatures, allow it to warm to room tem- perature before turning on the power. If you do not do this, the console displays or other electrical components may become damaged.

Plug in the power cord

 

 

 

 

 

 

 

(see page 12). Next, locate

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Reset

 

 

 

 

 

the reset/off circuit breaker

 

 

 

 

 

 

 

Position

 

 

 

 

 

on the treadmill frame near

 

 

 

 

 

 

 

 

 

 

 

 

 

the power cord. Switch the

 

 

 

 

 

 

 

 

 

 

 

 

 

 

circuit breaker to the reset

 

 

 

 

 

 

 

 

 

 

 

 

 

 

position.

 

 

 

 

 

 

 

Next, stand on the foot rails of the treadmill. Find the clip attached to the key (see the drawing above) and slide the clip onto the waistband of your clothes. Then, insert the key into the console. After a moment, the displays will light. IMPORTANT: In an emergency sit- uation, the key can be pulled from the console, causing the walking belt to slow to a stop. Test the clip by carefully taking a few steps backward; if the key is not pulled from the console, adjust the posi- tion of the clip.

13

Image 13
Contents Model No. PATL50707.0 Serial No QUESTIONS?Table of Contents Important Precautions Page Before YOU Begin Make sure that the power cord is unplugged AssemblyPage Outer side of the Frame Spacer facing See the left inset drawing. Identify the twoDo not tighten the Bolt yet See the left inset drawing. Identify the outerConsole Wire Tie Bracket Large Hole Con sole Gas Spring. Be careful to avoid losing Knob Spring Collar Large Hole Pin HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Features of the Console Console DiagramHOW to Turn on the Power Select the manual mode HOW to USE the Manual ModeInsert the key into the console Change the incline of the treadmill as desiredAdjust the incline of the treadmill to the lowest When you are finished exercising, removeWhen you fold the treadmill to the storage posi Rate will be shown. For the most accurate heartSelect one of the six speed workouts HOW to USE a Speed WorkoutHOW to Fold the Treadmill for Storage HOW to Fold and Move the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USE Problem The power turns off during use TroubleshootingTop View Problem The walking belt slows when walked on Exercise Intensity Exercise GuidelinesWorkout Guidelines Exercise FrequencyQty Description R0907ADescription Exploded Drawing A-Model No. PATL50707 Exploded Drawing B-Model No. PATL50707.0 Exploded Drawing C-Model No. PATL50707.0 Exploded Drawing D-Model No. PATL50707.0 Limited Warranty Ordering Replacement PartsIcon Authorized Dealer