ProForm PATL40907.0 user manual Screws before tightening any of them

11.Set the Pulse Bar Bottom (95) on the Left Handrail (35) and the Right Handrail (33). Press the Pulse Bar Bottom forward as you tighten two #10 x 3/4" Screws (5) with two #10 Star Washers (10) into the Handrails.

Remove the long tie from the Upright Wire (38).

12.With the help of a second person, hold the con- sole assembly near the Right Handrail (33) and the Left Handrail (not shown).

Connect the Upright Wire (38) to the Console Wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT CON-

NECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN YOU TURN ON THE POWER. Insert the connectors and the excess wire into the Right Handrail (33).

13.Connect the console ground wire to the handrail ground wire.

Set the console assembly on the Right Handrail (33) and Left Handrail (35). Make sure that the wire harnesses are not pinched. Attach the console assembly with two #8 x 1/2" Screws (1), four #8 x 3/4" Screws (12), and four #8 x 1/2" Washer Head Screws (112). Start all the

Screws before tightening any of them.

Cut the plastic tie from the Right Handrail (33).

See steps 5 and 7. Firmly tighten the four 3/8" x 4" Bolts (6).

11
		35
		10	Long Tie
		5
			5	38
		95	10
			33
12
		Console	Console
		Wire	Assembly
	33	38
			Console
			Wire
			38
13		Console
		Assembly
				35

Ground Wires

	Plastic		12
112	Tie		112
	12	1
33	12

10