ProForm 620 Make sure that the power cord is unplugged, Do not fully fold the Frame yet

1. Make sure that the power cord is unplugged.	1
With the help of a second person, carefully tip				B
				A
the treadmill onto its left side. Partially fold the
Frame (56) so that the treadmill is more stable;				Hole
do not fully fold the Frame yet.
			38	83
		Tie
Remove and discard the two indicated bolts (A)
				81
and the shipping bracket (B).
Cut the tie securing the Upright Wire (38) to the				2
Base (83). Use the indicated tie to pull the
Upright Wire out of the indicated hole.
Attach a Base Pad (81) to the Base (83) in the
location shown with a Base Pad Spacer (13) and		13
a #8 x 1" Tek Screw (2). Then, attach another	56		81
Base Pad (81) with only a #8 x 1" Tek Screw (2).
			2
2. Remove the 3/8" Nut (8), the 3/8" x 2" Bolt (4),	2
and the shipping bracket (C) from the Base (83).
Attach a Wheel (84) with the Bolt and the Nut
that you just removed. Do not overtighten the
Nut; the Wheel must turn freely. Discard the
shipping bracket.		83
		4
			84
		C
		8
3. Identify the Right Upright (78) and the Right	3
Upright Spacer (79), which are marked with
stickers. Insert the Upright Wire (38) through the				78
Right Upright Spacer as shown.
	38
See the inset drawing. Tie the long tie in the				38
Right Upright (78) securely around the end of
	Long			79
the Upright Wire (38). With the help of a second
	Tie			83
person, hold the Right Upright near the Base
(83). Then, pull the other end of the long tie until
the Upright Wire is routed completely through
the Right Upright.
		78
	38	Long
		Tie
	7