5.Touch the Right Handrail (72) to discharge any static. Slide the sleeve off the connector on the Upright Wire (42) as shown in the inset drawing. Next, press the end of the Upright Wire into the socket in the bottom of the Console Base (47). The connector should slide easily into the socket and snap into place. If the connector does not slide easily and snap into place, turn the connec- tor and then insert it. Then, slide the sleeve back over the connector.
6.Set the Console Base (47) on the Handrails ( 71, 72). Attach the Console Base with four 3/4” Screws (2). Start all four Screws before tightening them; do not over- tighten the Screws.
See the lower drawing. Make sure that the Upright
Wire (42) is routed below the two indicated round posts (A). Next, press the Upright Wire into the slot be- tween the square post (B) and the Console Base (47).
7.Cover the Upright Wire (42) with the Right Grip Plate
(36). Be careful not to pinch the Upright Wire. Tighten a 3/4” Screw (2) and two 1/2” Screws (48) into the Right Grip Plate and the Console Base (47).
Attach the Left Grip Plate (32) over the ground wire and the other wires with a 3/4” Screw (2) and two 1/2” Screws (48). Be careful not to pinch any of the wires.
5 |
|
|
72 |
|
|
|
| 42 |
|
| 47 |
| Sleeve | Connector |
42 |
|
|
6 |
| 47 |
|
| |
72 |
| 71 |
2 |
|
|
|
| 2 |
| A |
|
|
| B |
42 | 47 |
|
7 |
| 47 |
|
| Ground |
|
| Wire |
|
| 42 |
| 36 | 32 |
|
| |
| 2 | 2 |
48 |
| |
| 48 | |
|
|
8