12.While a second person holds the Console (6) near the Console Plate (19), connect the wires on the Console to the Main Wire (31) and to the Pulse Wire (52).
Insert the excess wire into the Console Plate
(19)or into the Console (6).
Tip: Avoid pinching the wires. Attach the Console (6) to the Console Plate (19) with four M4 x 16mm Screws (40).
13.Attach the Water Bottle Holder (49) to the Upright (3) with two M4 x 22mm Screws (54).
14.Identify the Right Pedal (26), which is marked with an "R." Using an adjustable wrench, firmly tighten the Right Pedal clockwise into the right arm of the Crank (13).
Tighten the Left Pedal (not shown) counter= clockwise into the left arm of the Crank (not shown).
Adjust the strap on the Right Pedal (26) to the desired position, and press the end of the strap onto the tab on the Right Pedal. Adjust the strap on the Left Pedal (not shown) in the same way.
12
6
19
13
49
14
26
15.Make sure that all parts of the exercise bike are properly tightened. Note: over after assembly is completed. To protect the floor or carpet from damage, bike.
Some hardware may be left place a mat under the exercise
11