,
,
Orient the Upright (3) as shown. Have a second person hold the Upright near the Frame (1).
Locate the wire tie in the lower end of the Upright
(3). Tie the wire tie to the Main Wire (31). Then, pull the upper end of the wire tie until the Main Wire is routed through the Upright.
Tip: To prevent the Main Wire (31) from fall-
ing into the Upright (3), secure the Main Wire with the wire tie.
Tip: Avoid pinching the Main Wire (31). Set the Upright (3) on the Frame (1).
Attach the Upright (3) with four M8 x 25mm Button Screws (44) and four M8 Split Washers (45). Tip: Start all the Button Screws before fully tightening them.
Wire Tie
3__/
Wire Tie
31
Avoid pinching the
Main Wire (31)
44
44
7