ProForm PFBE3006.0 user manual Make sure that the Barbell is centered

20. Orient the Locking Bar (50) as shown. Slide the	20
Barbell (51) through the Left Barbell Guide (52),
the Locking Bar, and the Right Barbell Guide (53).	53
Make sure that the Barbell is centered in the
Barbell Guides. Engage the Locking Bar into the	50
Uprights (43) at the lowest position.
					Hole
			43		52
					51
21. Hand tighten an M8 x 20mm Button Screw (16)	21
into the Left Barbell Guide (52).
Slide a Weight Stop (69) onto the Barbell (51).				41
Hand tighten an M6 x 15mm Button Screw (96)
					59
into the Weight Stop. Make sure that the Button	60
Screw is tightened enough to engage the hole
					39
(see drawing 20) in the Barbell.
Repeat this step on the other side of the					60
				51
Barbell (51).		52
Tighten the Button Screws used in this step,			16
		43		96	69
and the Bolts and Nylon Locknuts used in
steps 11–15 and 17–19.
Press two Center Base Feet (60) onto the Center			64
Rack Base (39). Press the Rear Upright Foot (59)
onto the Rear Upright (41). Press two Front
Upright Feet (64) onto the Front Uprights (43).	22
22. Route a Cable (61) up through the Top Frame			45
(45) and over a Pulley (63). Attach the Pulley	80
			63
inside the Top Frame with an M10 x 67mm Bolt
(86), two M10 Washers (80), two 16mm x 12.5mm	77
Spacers (76), and an M10 Nylon Locknut (77).
	76
	61		76
			80
			86
23. Route the Cable (61) over a Pulley (63) and down	23		63
through the Top Frame (45). Attach the Pulley
	77	80
inside the Top Frame with an M10 x 67mm Bolt			76
(86), two M10 Washers (80), two 16mm x				45
12.5mm Spacers (76), and an M10 Nylon Locknut
(77).
			61	76
				80
				86
	12