ProForm PFBE1516.0 user manual Adjusting the Weight Rests, Weight Rests are at the same height

Page 12

ADJUSTING THE WEIGHT RESTS

To adjust the position of the Weight Rests (13), remove the Pins (34) from the Left and Right Uprights (6, 7). Raise or lower the Weight Rests to the desired position. Reengage the Pins into the Weight Rests and the Left and Right Uprights. Make sure that the

Weight Rests are at the same height.

REMOVING THE CURL BAR

To remove the Curl Bar (11), remove the Curl Pin (38) from the Leg Lever (10).

STORING THE WEIGHT BENCH

Remove the Seat Frame Knob (62) from the Seat Frame (2), and lift the weight bench to the position shown. Insert the Seat Frame Knob into the indicated hole in the Support (5) and the Seat Frame. Make sure that the Seat Frame Knob is inserted through the Seat Frame.

13
	34
	6
7	34
	13
	10
11
38
	2
	Hole
	5
	62

12

Image 12

Contents QUESTIONS? Model No. PFBE1516.0 Serial NoCall TOLL-FREE Table of Contents Important Precautions Assembled Dimensions Before YOU BeginPart Identification Chart Assembly Make Assembly EasierDo not tighten the Button Screws yet Button Screws yetTighten the Button Screws 47, 50, 59 used in and this step Locknuts yet Repeat this step with the other two Pad Tubes Repeat this step for the other side of the weight bench Adjustments Adjusting the BackrestUsing the Curl PAD Using the LEG LeverAdjusting the Weight Rests Weight Rests are at the same heightStoring the Weight Bench Removing the Curl BARExercise Guidelines Muscle Chart Cooling DownStaying Motivated Exercise Weight Sets Reps DateAerobic Exercise Thursday Aerobic Exercise DateMonday Page Part LIST-Model No. PFBE1516.0 Qty DescriptionExploded DRAWING-Model No. PFBE1516.0 Ordering Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT